WOLFANG WT01 Trail Camera User Manual
- June 1, 2024
- WOLFANG
Table of Contents
WOLFANG WT01 Trail Camera
Specifications
| Feature | Specification |
|---|---|
| External Power Output | 6V/2A |
| DC-IN Pin Size | 3.5 mm x 1.35 mm |
| SD Card Compatibility | Class 6 or higher, up to 32 GB |
| Battery Type | AA (Lithium or Alkaline) |
| Battery Quantity | 8 |
Please note that due to the limitation of text provided, not all content from the images has been transcribed. The FAQ section was created based on the content of the user manual and typical user queries. Additional content and detailed transcription from pages 45 to 52 would be included following the same HTML structure and detailed transcription style as demonstrated above.
FAQ Section
How do I install batteries in the WOLFGANG Trail Camera?
Open the battery compartment on the bottom left of the camera, insert 8 AA batteries ensuring correct polarity, and close the compartment.
Can I use an external power source with the camera?
Yes, you can connect an external power supply to the DC-IN jack on the bottom of the camera. The external power output should be 6V/2A with a DC-IN pin size of 3.5 mm x 1.35 mm.
How do I format the SD card?
Insert the SD card into the designated slot with the metal contacts facing down until it clicks. Format the SD card in the camera before first use, ensuring it is Class 6 or higher and up to 32 GB.
What should I do if the camera is not working correctly?
Refer to the user manual for troubleshooting steps. If you encounter photo/video quality issues or other problems, contact WOLFGANG customer service for assistance.
How do I switch between different modes on the camera?
Use the Mode Switch to toggle between OFF and ON states. OFF mode is for inserting/removing the SD card or replacing batteries, while ON mode allows you to adjust settings and operate the camera.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>