T6 Pro Headset TWS BT Tracer Gamezone Instruction Manual

T6 Pro Headset TWS BT Tracer Gamezone

Specifications

• Brand: Tracer
• Model: Gamezone T6 Pro TWS BT
• Charging Voltage: DC 5V
• Power Range: 0.15 W – 1.5 W
• Charger: Not included

Product Usage Instructions

Turning On
To turn on the earphones, open the charging case or touch them.

Charging Instructions

• The LED indicator on the charging case will light up for a few seconds when opened or closed.
• The earphones will flash slowly in blue while charging and turn off when fully charged.
• Use a charger with an output between 0.15 W and 1.5 W for optimal charging speed.

Games Mode

• Press and hold the multifunction button on the right earbud for 2 seconds to enter Games Mode.
• Press and hold again to switch back to music mode.

Factory Settings

• To restore factory settings, tap both earbuds five times quickly when they are turned on but not connected to any BT devices.
• The earphones will automatically turn off and reset after 3 seconds. Place them back in the case to complete the process.

Specification

• BT Version: V5.3
• Working Range: Up to 10m
• Speaker size: φ13mm
• Impedance: 32Ω
• Mic Type: Silicon Microphone(MEMS Microphone)
• Mic Sensitivity: -32dB±3dB
• Speaker Power: 20mW*2
• S/N Rate: ≥70DB
• THD: ≤ 5%
• Frequency Response: 20Hz-20KHz
• Playing time: up to 5h
• Earphone battery: 35mAh
• Charge case battery: 300mAh
• Maximum Transmitter Power (E.I.R.P) ≤20 dBm
• The range of which the device operates: 2400 MHz – 2483,5 MHz

In the box

• BT Earphone ×2
• Charge Cable ×1
• Charge Case ×1
• Manual ×1
• Eartips ×3 sets

Operation Instruction

1. TURN ON: Open the charging case, or touch and hold the MF button for 5 seconds the earbuds will turn on automatically. And you will hear a prompt voice.
2. TURN OFF: Put the earbuds into the charging case and close the case, or touch and hold the MF button for 5 seconds the earbuds will turn off automatically. And you will hear a prompt voice.
3. Connect with bluetooth : Turn on the device of BT and find “TRACER T6 PRO” to pair.
4. Short Press: Short Press (Touch) the MF button of the Left Earphone to Decrease Volume.Short Press (Touch) the MF button of the Right Earphone to Increase Volume.
5. Double Press : Double Press on the M button to Pause/Play Music, Answer incoming calls, and End a call. Press (Touch) the MF button of either earphone for 2 seconds and release to Reject Incoming Call.
6. Triple Press: Previous track: Short Press(Touch) the MF button of the Left Earphone Triple. Next track: Short Press (Touch) the MF button of Right Ear-phone Triple.
7. Short hold of multifunction button for 2 seconds on left earbud to activate Siri, and Short hold again to exit Siri.
8. Games Mode: Short hold of the multifunction button for 2 seconds on the right earbud to enter the Games Mode, Short hold again to switch to the music mode.
9. Restore factory settings: When the earphone is turned on but without connection to any BT devices,5 times quickly tap both of the earbuds, the 2 earbuds with LED indicator at the same time, after 3 seconds the earphone will turn off automatically and get re-stored factory settings, put the earphones back to the case and close case, a once open case both earphones will get connected automatically.

Led Indicator Display

• Turn On: The LED light indicator on the earphones will be with a breathing flash in ice blue.
• Turn Off: The LED light indicator on the earphones will be off.
• TWS connected: The LED light indicator on the host earphone will be with a breathing flash in ice blue. and the subordinate earphone light is off.
• BT Connected: The LED light indicator on the earphones is off.
• To Charge the Earphone: The LED light indicator on the earphones will be with a bra-eating flash in ice blue to indicate the battery is being charged, once fully charged, the light will be off.
• To Charge the Case:
  • Charger not included.
  • The charging voltage of the headphone case is DC 5V. The power provided by the charger must be between the minimum 0.15 W is required by the radio device and a maximum of 1.5 W is to achieve the maximum charging speed. a. Open the Case, The ice blue LED light indicator on the charging case will light up for 5s then be off (with/without the earphone in the charging case).
  • b. Close the Case, The ice blue LED light indicator on the charging case will light up for 10 then be off (with/without the earphone in the charging case)
  • c. When the LED indicator light on the charging case is flashing in blue or does not light up, indicating that the charging case is in low battery or 0% battery.

Use safety instructions
To avoid hearing damage, keep the volume at a moderate level. Avoid listening to music at high volume for a long time, as this may cause permanent damage to your hearing or deafness. Please do not use Tracer T6 Pro when driving, riding a bicycle, crossing the road, etc. where your concentration is required.

Note: If you use the headset while watching a video, the audio and video may be slightly out of sync.
After charging is complete, please unplug the charging cable from the product to avoid leaving the product in a charging state for a long time. Do not use a charger that exceeds the rated voltage and current of the headset (5V/1A) to charge the headset.
If the output voltage and current of the charger exceed the specified standards, this will cause serious damage to the product, and the product warranty will be validated at the same time.

Charger not included.
The charging voltage of the headphone case is DC 5V. The power provided by the charger must be between the minimum 0.15 W required by the radio device and the maximum 1.5 W to achieve the maximum charging speed.

Producent
Megabajt Sp. z o.o., ul. Rydygiera 8, 01-793 Warszawa

Frequently Asked Questions

• Q: Is the charger included in the package?
  • A: No, the charger is not included. You need to use a charger with an output of DC 5V.
• Q: How do I know if the charging case is low on battery?
  • A: The LED indicator on the charging case will flash in blue when the battery level is low. If it doesn’t light up, the case is discharged.

DISPOSAL

The crossed-out waste bin symbol placed on the equipment, packaging or documents attached to it means that the product must not be disposed of with other waste. Waste equipment may contain substances that are toxic and carcinogenic, hazardous to human health and life, and also pollute the soil and groundwater. It is the user’s responsibility to return used equipment to a designated collection point for proper processing. More information about equipment disposal points can be obtained from local authorities, waste disposal companies or where you purchased this product.

The household plays an important role in contributing to the reuse and recovery of secondary raw materials, including recycling, of used equipment. At this stage, attitudes are formed that influence the preservation of the common good, which is a clean natural environment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>