TEKA GFL 57760 Built In Absorber User Manual

TEKA GFL 57760 Built In Absorber User Manual

User Manual GFL 651 EOS GFL 760 EOS IX

Dear Customer,

Congratulations on your choice. We are certain that this modern, functional and practical device made with first rate quality materials will fully satisfy your requirements.
Please read all the sections in this INSTRUCTION MANUAL before using the hood for the first time in order to obtain maximum performance from the device and avoid faults which may arise from incorrect use as well as minor problem solving.
For optimal performance, the external duct should not exceed FOUR METRES, have more than two 90 ° angles and its diameter should be at least Ø120.

Safety Instructions

• Disconnect the device before performing any work on the interior, e.g. during cleaning or maintenance.

• The excessive accumulation of grease in the hood and metal filters may cause dripping and fire risks, therefore it is necessary to wash the inside of the hood and the metal filters at least once a

• This device can be used by children aged 8 and over and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge, if they have been given supervision or proper training in the safe use of the device and if they understand the dangers Children should not play with the device. Cleaning and maintenance should be performed by the user and not by unsupervised children.

• The regulations for electrical installations must be complied

• Check that the power voltage and frequency match those indicated on the label located on the inside of the A suitable earth must be connected (except for Class II devices, marked with on the technical data plate).

• For installation, a connection method isolated from the fixed installation should be incorporated, in accordance with installation regulations (adjusted to the strength to be endured and with a minimum opening between the contacts of 3mm) under overvoltage category III conditions, for the emergency shutdown, cleaning or light In no event should the earth pass through this switch. This switch can be replaced with a plug if it is accessible in normal use.

• If the power lead is damaged it must be replaced by the manufacturer, its after-sales service or by qualified personnel in order to avoid potential

• Ventilation regulations must be complied

• Air should not be extracted by ducts used to expel fumes from equipment powered by gas or other

• The room must be adequately ventilated when the hood will be used simultaneously with equipment powered by energy other than electricity g. gas cookers.

• Do not produce flames under the

• The bottom of the hood must be fitted at least 65cm above gas or combination Observe the minimum limits set by worktop manufacturer’s. This distance may be reduced if mentioned in the hood installation instructions.

• Accessible parts can be heated when used with cooking

• Never leave gas burning without a pan above The grease accumulated in the filters may drip or catch fire when the temperature is increased.

• Avoid cooking under the hood if the metal filters are not fitted g. while they are being cleaned in the dishwasher.

• We recommend you wear gloves and use extra caution when cleaning the inside of the

• Your hood is designed for domestic use and only for the extraction and purification of gases from food Use for other purposes is at your own risk and may be dangerous.The manufacturer is notresponsible for damage caused by improper use of the device.

• For repairs please contact the manufacturer’s nearest Technical Assistance Department which will always use genuine Repairs or modifications by unauthorized personnel may result in damage to equipment or malfunction, endangering safety.

• This device complies with the European Directive 2012/19/EU on electrical and electronic devices entitled “Electrical and Electronic Equipment Waste “. The directive provides the framework applicable throughout the European Union for the return and recycling of electrical and electronic equipment waste [symbol] responsible for his/her Keep children away from the device and never let them play with it .

• Replace any cracked

Installation

• The installation instructions are defined on the images at the beginning of this user
• First, remove the protective foil from the back of the appliance and, following installation, remove the foil

Instructions for use

You can activate or deactivate the cooker hood by operating the functions shown in the diagram.
Switch on the extractor fan a few minutes before you start to cook in order to ensure that a steady air flow has been established before fumes appear.
Allow the extractor fan to run for several minutes after you have finished cooking (between 3 to 5 minutes) in order to expel all the grease from the outlet duct. This prevents the return of grease, smoke and smells.

1. Lighting
2. Selected speed increase
3. Selected speed decrease
4. Timer

Program the working time

• By pressing + / – turn on the hood and choose the desired suction speed
• Press the Timer The light will start flashing.
• The duration of the programming time is approximately 15
• During the programmed time you can change the suction
• The Intensive speed is self-programmed and will switch to speed 2 after approximately 7

Fresh Function

• The fresh function consists on activating the motor at speed 1 for ten minutos each hour. This function will stay active for 24h or until it is manu- ally turned off.
  • To activate/deactivate this function, press the “ – ” button for 3

Cleaning and maintenance During cleaning and maintenance work, make sure the safety instructions are complied with.

 Cleaning the hood body

• If your kitchen hood is made of stainless steel, use proprietary cleaners mentioned in the product
• If your kitchen hood is painted, use lukewarm water and a neutral
• Never use metallic scourers, nor abrasive or corrosive
• Dry the kitchen hood using a cloth that does not produce Do not use vapour cleaners.
• To remove the filters from their fittings, press lightly on the locks and then pull them

Cleaning the metal filters

• To remove the filters from their fittings, press lightly on the locks and then pull them
• The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special anti-grease products. They can also be washed in a dishwasher. In this case, it is advisable to stack them vertically to avoid food residues to stick to
• Cleaning in a dishwasher may damage the metallic surface (blackening it), although this will not affect its fat retention
• Once clean, leave them to dry off and then fit them onto the kitchen

Problem solving

Proceed with the following checks before calling the Technical Service:

The kitchen hood does not work.

| The mains cable is not connected to the network.

There is no current in the network.

|

Connect the mains cable to the network.

Provide current to the network.

The kitchen hood does not extract sufficiently or vibrates.

|

Filters are saturated with fat. Obstruction in the air outlet.

| Change or clean the active charcoal and/or metal filters.

Remove the obstruction.

Active charcoal filters (Optional)

•   To install the active carbon filter follow the instructions supplied with it.

• The manufacturer reserves the right to make any corrections it deems necessary to its devices without damaging its essential characteristics.

•   It is possible that with the installation of carbon filters, a reduction in the extraction flow can be observed in the hood.

Lights For changing the light bulbs please contact the manufacturer’s nearest Technical Service.

Lamp code:
150 mm: 81493014
200 mm: 81493015
250 mm: 81493033

ILCOS D CODE:
GFL 5: DSL-2-S-150
GFL 7: DSL-3-S-200
GFL 8: DSL-3-S-250

Read More About This Manual & Download PDF:

References

• Teka | Cook your way to life

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>