FAHRENHEIT 28091 Soldering Iron Instruction Manual
- June 1, 2024
- FAHRENHEIT
Table of Contents
FAHRENHEIT 28091 Soldering Iron
Use
30 W model for radio engineering, hobby, DIY, and small electric devices.
How to solder
-
Clean the soldering surface from dirt, paint, and rust.
-
Heat that point with the soldering iron that you need to solder.
-
Use a resin-based tin for welding and smelt a little bit to the soldering surface, using the soldering iron.
Note: If you do not use a resin-based tin for welding please make sure before use there is enough soldering paste on the soldering surface. -
Join the two soldering points then wait until the tin for welding gets cool. Do not move the soldered elements.
Warning
- Please use the soldering iron carefully. The high-temperature soldering iron can cause fire or burn injuries.
- At the first use the barrel part of the iron may smoke until the heating parts warm up/dry. It takes a maximum of 10 minutes.
- Never rasp or scratch the special covered soldering tip.
Specifications
| Property | Details |
|---|---|
| Use | 30 W model for radio engineering, hobby, DIY, and small electric devices. |
FAQ
What is the primary use of the 28091/28092 soldering iron?
The soldering iron is intended for radio-engineering hobby DIY and small electric devices.
How do I prepare the surface for soldering?
Remove any dirt paint or rust from the surface that needs to be soldered.
What type of solder should I use?
It is recommended to use a resin-based tin for welding. If not using resin- based tin ensure there is sufficient soldering paste on the surface.
How long should I wait after soldering before moving the elements?
Wait until the solder cools down completely before moving the soldered elements.
Is there any risk when using the soldering iron for the first time?
Yes the barrel part of the iron may emit smoke as it heats up for the first time. This is normal and should cease within 10 minutes.
How do I care for the soldering tip?
Do not rasp or scratch the special coated tip of the soldering iron to avoid damage.