Peg Perego Tatamia Follow Me Feeding High Chair Instruction Manual
- June 1, 2024
- Peg Perego
Table of Contents
Peg Perego Tatamia Follow Me Feeding High Chair
Thank you for choosing a PegPerego product.
WARNING IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE
- Never leave the child unattended.
- Never leave the baby alone without supervision.
- Always use the restraint system
- Falling hazard: Prevent your child from climbing on the product
- Do not use the product unless all components are correctly fitted and adjusted
- The product must be assembled and adjusted by an adult. Do not use the product if it is not properly assembled, if it is broken or if pieces are missing.
- Prevent the child from falling or slipping; always use the five-point safety harness. Use the safety harness both when the seat is reclined and when it is in the vertical position.
- Do not place your fingers in the mechanisms and make sure the child’s limbs are safe from harm when adjusting the chair.
- Only replacement parts supplied or recommended by the manufacturer/distributor shall be used.
- Assembly, preparation, cleaning and maintenance of the product must only be carried out by adults.
- Do not leave the high chair exposed to sunlight for long periods of time. Wait until it has cooled down before sitting the child in the chair.
- To make sure that any harness is correctly fitted
- Do not use accessories or replacement parts other than those approved by the manufacturer.
- WARNING: Do not let the child play with this product. This product is not a toy.
- Never carry the high chair with the baby inside.
RECLINER CRADLE MODE
- Do not use the reclined cradle once your child can sit unaided.
- This reclined cradle is not intended for prolonged periods of sleeping.
- It is dangerous to use the reclined cradle on an elevated surface, e.g. a table.
- When used as a recliner, this product is designed for children from birth up to a weight of 9 kg.
- Never allow a child to sleep in this product. This product is not a replacement for a cot or bassinet.
- Shoud your child fall asleep, move them to a suitable cot or bassinet.
- Danger of strangulation: never leave the child in the recliner if the safety harness is loose or undone.
- WARNING! Always apply the brake when stationary.
SWING
- When used as a swing, the product is designed for children from birth up to 6 months of age and max 9 kg.
- Keep a close eye on other children near the product.
- To use the product as a swing, make sure that the seat is always in the lowest position with backrest completely down.
- Always use the protective front bar. It is not a replacement for the safety harness.
- The product is designed for family domestic use and for indoor use only.
- WARNING! Always apply the brake when stationary.
HIGH CHAIR
-
Be aware of the risk of open fire and other sources of strong heat in the vicinity of the product.
-
Keep the high chair with the baby far from stoves, stairs and warming devices.
-
Be aware of the risk of tilting when your child can push its feet against a table or any other structure.
-
This product is intended for children able to sit up unaided and up to 3 years or a maximum weight of 15 kg.
-
Do not use the product as a high chair until the child can sit up alone. The tray and its accessories are not designed to support the child’s weight.
-
The tray is not designed to keep the child in the seat and does not substitute the safety harness.
-
Make sure the product is placed on a flat surface.
-
Position the product so that the child is far from dangers such as electrical wiring, heat sources and flames.
-
Do not use the product near stairs or steps.
-
The high chair is designed for use at tables without the tray. It is suitable for children from 12 months of age up to a weight of 15 kg.
-
WARNING! Always apply the brake when stationary.
-
WARNING! To avoid injury ensure that your child is kept away when unfolding and folding this product.
A single product which follows the growth of your child. -
From 0 to 6 months, a comfortable recliner and swing.
-
From the age of 6 months, a high chair for eating, playing and relaxing.
-
From the age of 12 months, a high chair without a tray, for sitting at the table with the adults.
The images referring to the textile details may differ from the collection purchased.
For more information, consult our website: www.pegperego.com
INSTRUCTIONS FOR USE
-
ASSEMBLING THE WHEELS: Carefully assemble the wheels correctly before opening the high chair.
ASSEMBLING THE REAR WHEELS: the two rear wheels, with a red collar (fig. a), must be hooked onto the rear base of the product, using the high chair backrest as a reference (fig. b).
Insert the wheels and push the red collar as far as it will go against the base (fig. c). -
ASSEMBLING THE FRONT WHEELS: the two front wheels, without a red collar (fig. d), must be hooked onto the front base of the product, using the footrest as a reference (fig. e). Insert them as far as they will go against the base (fig. f).
-
OPENING: Lower the two support base sections one after the other to open the high chair. Slightly tilt the high chair to the side opposite the base section you are lowering (fig_a) and check the green rectangle to ensure it is open properly (fig_b).
WARNING: If the red rectangle is visible, the base has not been opened properly. -
Before using the high chair, raise the seat (fig_a), completely recline the backrest until it clicks into position (b) and make sure the pin is properly locked in place (fig_c).
-
FIVE-POINT SAFETY HARNESS: To fasten the harness, insert the two waist strap buckles (with shoulder straps attached) into the leg divider strap until you hear a click (fig. a). To release it, press the sides of the buckle and simultaneously pull the waist strap outwards (fig. b). To tighten the waist strap, pull from both sides in the direction of the arrow (fig. c). To loosen it, do the opposite. The waist strap can be tightened as far as the safety stop (fig. d).
-
The shoulder straps of the harness can be set at two different heights. Partially remove the sack (fig_a), release the shoulder straps from the backrest (fig_b) and pull them out from the sack (fig_c).
-
Insert the ends of the shoulder straps in the other slots in the sack (fig_d) and the backrest (fig_e), then put the sack back into the right position on the backrest.
-
BRAKE: The product is packaged with the brakes on.
To move the high chair, press the lever and move it forward until you can see GO (fig. a).
This will allow the high chair to be moved around freely; you don’t need to keep pressing it.
To put the brakes on, move the lever back until you can see the word STOP and then release the button (fig. b). Wheels are non-scratching.
RECLINER-SWING -
FOOTREST FOR EARLY MONTHS: The high chair is fitted with a footrest for use when it is in the recliner-swing mode. Raise the footrest by rotating it upwards (fig. a). Fold it away by pressing the two side buttons (fig. b) and rotating it downwards (fig. c).
-
RECLINER-SWING: Before placing the high chair in the recliner-swing mode, remove the tray (fig. a) and insert the front bar (fig. b). To remove the protective front bar, press the two buttons at its base and pull it out (fig_c).
-
SWING: To transform the chair into a swing, place the seat in the lowest position (fig. a) and press the red buttons on the inner part of the uprights, pushing them upwards (fig. b). Swing mode (fig. c).
-
To put it back in a recliner or high chair mode, make sure that the side uprights of the seat are parallel with those of the frame (fig_a), then press the red buttons and push them downwards (fig_b).
-
RECLINER CONFIGURATION: – Remove the tray. – recline the backrest to the 3/4 position (fig_a) – lift the footrest (fig_b) – the recliner’s height can be adjusted as needed (fig_c).
HIGH CHAIR -
FOOTREST: Lower the footrest (fig. a), press the two side buttons (fig. b) and select one of the three available heights.
-
TRAY: To fit the tray, pull the central lever underneath it towards you while at the same time pushing it into the armrests (fig_a). To extend or remove the tray, pull the central lever underneath it towards you (fig_b) and move it outwards (fig_c). To remove the tray, pull the side levers outwards and pull the tray towards you. The high chair has a double tray. The top tray can be easily washed in a dishwasher. To remove it, detach it from the lower tray and lift it up (fig. d).
-
USE WITHOUT THE TRAY: to use the seat at the table, remove the tray.
-
ADJUSTING THE HEIGHT: The seat can be set at 9 different heights. To raise or lower the seat, pull the two levers upwards (fig. a) and move it to the required position. This can also be done with the child in the high chair.
-
RECLINING BACKREST: The seat can be reclined in four positions: for eating, playing, relaxing or sleeping. To adjust it, raise the handle behind the backrest (fig. a) and lock it in the required position (fig. b). This can also be done with the child in the high chair.
-
CLOSING AND REOPENING THE TRAY: Pull the central lever underneath it towards you (fig_a) and extend it as far as the red markers (fig_b), then swing it upwards to lock it in place (fig_c). To reopen the tray, swing it downwards then pull the central lever towards you and put the tray in one of the positions for use.
-
COMPACT CLOSURE: before closing the high chair, it is necessary to fold up the tray. Put the backrest in the vertical position, then pull the two red levers on the sides of the seat outwards (Arrow_a). Rotate it downwards (Arrow_b), lower the seat to the bottom position and fold away the footrest. To raise the support bases, press the red levers on the sides of the uprights (Arrow_c) and at the same time lift the grey levers (Arrow_d). The bases will lift up automatically (Arrow_e). The high chair is freestanding when folded up.
-
REMOVABLE COVERS: To remove the seat covers, remove the upper part of the sack, then pull the harness straps out through the backrest (fig. a) and through the sack (fig. b). Push a screwdriver into the hole in the leg divider and pull out the belt (fig. c).
-
Unbutton the sack at the sides (fig. d) and pull up to remove it (fig. e).
SERIAL NUMBERS -
Information about the production date of tatamia follow me can be found under the base.
Product name, date of manufacture and serial number.
This information is required for any complaints.
THE ORIGINAL ACCESSORY PEGPEREGO
PegPerego accessories are designed as a useful, practical means of simplifying
the lives of parents. Discover all your product’s accessories on
www.pegperego.com
CLEANING AND MAINTENANCE
Cleaning must only be carried out by adults.
- PRODUCT MAINTENANCE: protect from the weather: water, rain, or snow; prolonged and continuous exposure to bright sunlight may give rise to colour changes of various materials; store this product in a dry place. The maintenance has to be regular.
- CLEANING THE CHASSIS : periodically clean all plastic parts with a damp cloth. Do not use solvent or similar cleaning products; keep all metal parts dry to prevent rusting; keep moving parts clean (adjustment mechanisms, locking mechanisms, wheels, …) and free of dust and sand and, if necessary, lubricate with light machine oil all metallic moving parts. Check all nuts and bolts for tightness and tighten when required. check all coverings for bolts and sharp edges and replace them when required. check the swing seat and attachments for evidence of deterioration. Replace when required by the manufacturer’s instructions.
CLEANING THE SACK:
- When washing, closely follow the instructions stated on the label sewn into the cover.
Wash with a damp cloth and neutral detergent. Do not wring. Do not use chlorine bleach. Do not iron. Do not dry clean. Do not use solvents for stain removal. Do not spin dry.
PEGPEREGO S.p.A.
PegPerego SpA adopts a quality management system certified by TÜV Italia Srl
following the ISO 9001 standard. PegPerego can make changes at any time to the
models described in this publication for technical or commercial reasons.
PEGPEREGO AFTER-SALES SERVICE
If any parts of the item get lost or damaged, only use genuine PegPerego spare
parts. For any repairs, replacements, information on the products and sales of
genuine spare parts and accessories, contact the PegPerego Assistance Service
and state the serial number of the product.
tel. 0039/039/60.88.213
e-mail
customer.service@pegperego.com
website www.pegperego.com
All intellectual property rights on the contents of this manual are property of PegPerego S.p.A. and are protected by the laws in force.
Declaration of conformity
Product name: TATAMIA FOLLOW ME- Product reference number: IMTATA*- Reference Standards (origin): EN 12790-1:2023EN 14988:2017 + A1:2020 EN 71-2:2011+A1:2014, EN 71-3:2013+A1:2014, Regolamento (CE) N. 1907/2006 – All. XVII pt. 16,17,43,51,52 (REACH)- Declaration of conformity La PegPerego S.p.A. dichiara sotto la propria responsabilità che l’ articolo in oggetto è stato sottoposto a test di collaudo interni e omologato secondo le normative vigenti presso laboratori esterni ed indipendenti.- Date and place of issue: Arcore, September 2023 PegPerego S.p.A. Via De Gasperi, 50 20862 Arcore (MB), ITALY
PegPerego S.p.A.
VIA DE GASPERI 50 20862 ARCORE MB ITALIA
tel. 0039 039 60881
Servizio Post Vendita – After Sale:
tel. 0039 039 6088213
PegPerego U.S.A. Inc.
3625 INDEPENDENCE DRIVE FORT WAYNE INDIANA 46808
phone 260 482 8191 fax 260 484 2940
Call us toll free: 1 800 671 1701
PegPerego CANADA Inc.
585 GRANITE COURT PICKERING ONTARIO CANADA L1W3K1
phone 905 839 3371 fax 905 839 9542
Call us toll free: 1 800 661 5050
www.pegperego.com
Tutti i diritti di proprietà intellettuale relativi ai contenuti di questo
manuale d’istruzione appartengono a PegPerego S.p.A. e sono tutelati dalle
leggi vigenti.
All of the intellectual property rights for the contents of this instruction
manual belong to PegPerego S.p.A. and are protected by the laws in force
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>