Gritin G3901 Selfie Stick Tripod User Guide
- June 14, 2024
- Gritin
Table of Contents
Gritin G3901 Selfie Stick Tripod
Welcome
Thank you for purchasing this Gritin product. In order to ensure optimum
periormance and safety, please read this user manual carefully and keep it for
future reference. If you need any additional assistance, please contact our
customer support team or send us an email to
support@igritin.com .
Features
- Retracted Length: 15.2cm
- Extended Length: 75cm
- Weight: 140g
- Bluetooth Connection Distance: 10m
- The remote control battery can be replaced (Battery Model: CR1632)
Instructions
- Press and hold for about 3s to turn on the remote control, the LED indicator will flash.
- Turn on your phone’s Bluetooth function, search “GT S1” from the Bluetooth list and pairing. The LED indicator off after pairing.
- Open the selfie stick, put the phone in and adjust it to a suitable angle (If you need to shoot vertically, please rotate the clamp left and right)
- Press the remote control button to take photos remotely.
- Long press the remote control for 3 seconds to shut down.
Take Out and Load The Remote Control
How to Replace The Battery
Tripod Mode
Put your finger into the hole at the bottom of the selfie stick to open it
(Please pull out the last section of the pole and adjust it to be stable in
tripod mode)
How to Use Fill Light
- Press and hold the power button for 2s to turn on the light, then press to adjust the light mode:
- White light soft light, strong light
- Warm light soft light, strong light
- Natural light: soft light, strong light
- In any mode, long press the power button to turn off the light.
- When charging, the red light is on, and the light goes out when fully charged.
Replace The Camera Dock
- Unscrew the screw here.
- Take out the clip part of the selfie stick.
- Align the base into the groove.
- Retighten the screws.
Tips
- The selfie stick is compatible with Android 4.4 and iOS 5. 1 system or above.
- In order for the selfie stick to work well, please set the “volume button” to “shutter button” in the camera function settings for Android devices.
- After powering on, if there is no operation in the state of no pairing connection, the remote control will automatically shut down in 5 min; in the Bluetooth connection state, if there is no operation in 10 min, it will enter the dormant state, and it will automatically shut down after another 10 min without operation.
Attentions
- Please do not disassemble this product by yourself.
- Please keep your selfie stick away from water, fire, flammable gas and corrosive liquid.
- To avoid the danger of suffocation, please keep plastic bags away from babies and children.
ISED Statement
This device complies with Industry Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
The product comply with the Canada portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
Product Information
- Product Name: Selfie Stick
- Model: G3901
- IC: 28999-K9702
- Manufacturer: Shenzhen Teng Xun Zhan Yi Technology Co., Ltd.
- Manufacturer Address: Room 302, Building 8, Yunli Intelligent Park, Fada Road, Bantian Street, Longgang District, Shenzhen, Guangdong, China
- TEL: 1-800-360-5881
- EMAIL: support@igritin.com
- WEBSITE: www.igritin.com
- © Shenzhen Teng Xun Zhan Yi Technology Co., Ltd. All rights reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>