Segotep T1 Full Tower E-ATX Gaming PC Case Installation Guide

June 14, 2024
Segotep

Phoenix T1
Installation Guide

Cooling fan Installation

  1. Take out the front panel magnetic dust filter, take: down front-mounted fan bracket. Open both side panel (took-reed glass panel can be removed gently)
  2. Install the fan on the bracket and then install entire unit back to the case then fix it. ( 3pcs 120mm fans or 3pcs 140mm fans in front are supported)
  3. Take out the top-mounted dust falter and install the fan on the top of the case. (It supports 1pcs 120mm fans on the top)
  4. It support 3pcs 120mm fans or 2pcs 140mm fans in the rear

Liquid radiator installation

  1. Installation of front water cooler
    Remove the front panel first and install the fan and radiator on both side of the removable fan bracket. (Please confirm the direction of the air outlet before installation), then fix it with long screws. The front-mounted supports 20mnv360mm/280mm/240

  2. Installation of rear water cooler
    After fix the fan on the cooling with long screws, align the holes of the cooling with screws. The rear-mounted supports 360/280/240mm water cooling. (Maximum length is 415mm)

Har disk installation

Install SSD4 / 2 + HDD”2 simultaneously at structure
Install HDD
2 / 1+SSD*1 simultaneously at structure

VGA installation

  1. Fix the graphics card on the graphics card bracket with screws, and then move the graphics adapter cable to the empty slot on the left side of the bracket, as pictured. (Note: Graphics card bracket and graphics card adapter cable are optional)
  2. Lay down the case, take out the standard PCIE SIot, align the entire graphics card bracket with the SIot on the motherboard and insert the graphics adapter cable to the motherboard. (Note: where the SIot indicated by the arrow is)  
  3. Align the holes and use five screws to fix the entire graphics card bracket in the case.

Main cable connection, instructions for chassis

Segotep T1 Full Tower E-ATX Gaming PC Case - Fig11

JUSBC1: USB3.1 Gen2 Type-C port
Allow you connect USB3.1 Type-C port to it on the front panel. This port is with anti-reverse insertion design. Please connect with relevant direction when you connect to cable

Segotep T1 Full Tower E-ATX Gaming PC Case - Fig12

Airflow instruction manual

Segotep T1 Full Tower E-ATX Gaming PC Case - Fig13

Design of ATX3.0 takes off heat dissipation of whole case by horizontal airflow. At the same time, it supports up to 120mm fan*1 in the top. Installed direction of tower radiator should be confirmed as

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals