KERBL Gloves Cutter Top Cut Resistant Instruction Manual
- June 3, 2024
- KERBL
Table of Contents
KERBL Gloves Cutter Top Cut Resistant
Instructions for use
Results of the EN388:2016+A1:2018 mechanical test
- Abrasion resistance: 4 (min 0 / max 4)
- Blade cut resistance (Coupe – Test): X (min 0 / max 5)
- Tear resistance: 4 (min 0 / max 4)
- Puncture resistance: 3 (min 0 / max 4)
- Blade cut resistance (TDM): F (min A / max F)
The sign X, instead of a number, means that the glove is not designed for the use covered by the corresponding test. Results exclusively from samples of the inner hand of the glove
Care and Cleaning: The service stages mentioned are based on tests which
were carried out exclusively on unused gloves. Trans-fer of the results on
gloves after care treatment is not possible. The manufacturer accepts no
liability for changes to the properties. The condition of the gloves should be
checked before reuse. Packaging and storage: This article is supplied in
uniform sales packaging made from recyclable cardboard. PE-bags or similar
environmentally friendly coverings are the smallest packaging unit. The gloves
must be stored correctly, i.e. in boxes in dry rooms. The properties can be
altered by influences such as humidity, temperature, and light, as well as
natural alterations to the materials over a period of time.
Ageing: It is not possible to give an expiry date, as this can be dependent on
the degree of wear, use, and the area in which the gloves are used.
General information / Risk assessment: The glove types named here meet
with the requirements of regulation (EU) 2016/425 as brought into UK law and
amended, and is compliant with the above mentioned harmonized/designated
standards EN ISO 21420:2020, EN 388:2016+A1:2018 While selecting
an equipment, user should perform risk analysis based on the intended use and
determine the suitability based on product’s test standards and protection
levels obtained. Laboratory tests offer an aid to selection, however they
cannot take the actual workplace conditions into account. It is therefore the
responsibility of the user and not the manufacturer to test the suitability of
a certain glove for the planned area of use. Gloves for general light hand-
ling in wet conditions. The equipment provides protection against moderate
mechanical risks. The maximum wear time depends on the activity being carried
out and the person. The glove offers no protection against perforation with
sharp objects, e.g. injection needles. No gloves should be worn if there is a
risk of becoming caught in moving machine parts.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>