Oase 50355 Water Jet Lightning Instruction Manual

50355 Water Jet Lightning
Instruction Manual

Water Jet Lightning
Operating instructions

50355 Water Jet Lightning

Original operating manual. This operating manual belongs with the unit and must always be handed over together with the unit.
WARNING
▶ Disconnect all electrical units in the water from the power supply before reaching into the water. Otherwise there is a risk of injuries or death by electrocution.
▶ This unit can be used by children aged 8 and above and by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they are supervised or have been instructed on how to use the unit in a safe way and they understand the hazards involved. Do not allow children to play with the unit. Only allow children to carry out  cleaningand usermaintenance under supervision.

Questions, problems, missing parts?

Before returning the unit to your dealer, call us at 330-274-8317, Monday-Friday, or email us at customerservice@atlantic-oase.com.

Safety information

Electrical connection

• Special regulations apply to electrical installation in outdoor areas. Only allow a qualified electrician to  perform the electrical installation.
  – Th e qualified electrician has the required professional training, knowledge and skills to perform electrical installations in outdoor areas. The qualified electrician can detect potential risks and adheres to regional and national standards, regulations and
  directives.
  – For your own safety, please consult a qualified electrician.

• Install the transformer or the power pack at a minimum safety distance of 2 m (6.6 ft) from the water.

• Only connect the unit if the electrical data of the unit and the power supply match.

• Only connect the device to a correctly installed socket.

• The device is to be supplied through a residual current device (RCD) having a rated residual operating current not exceeding 30 mA.

• Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-proof).

• Protect open plugs and sockets from moisture.

Safe operation

• Never look directly into the light source of the unit.
• Do not use the unit, if electrical lines or the housing are damaged.
• Dispose of the unit if its power connection cable is damaged. The power connection cable cannot be replaced.
• Do not carry or pull the unit by its power cable.
• Route lines so that they are protected from damage and nobody can trip over them.
• Never make technical modifications to the unit.
• Only carry out work on the unit that is described in this manual.
• Only use original spare parts and accessories.
• Should problems occur, please contact the authorized customer service or OASE.

WARNING
Serious injury or death due to dangerous electrical voltage is possible with an electrical device in water operated with a voltage U > 12 V AC or U > 30 V DC.

▶ Disconnect all electrical devices in the water from the power supply before reaching into the water.
▶ Disconnect the device from the power supply before starting work on the unit.

WARNING
In the event of improper connection of the unit grounding, there is a risk of electric shock.
The unit must be grounded in order for the electrical current to be dissipated via the grounding and to reduce the risk of electric shock in the event of a malfunction or failure.

Instructions for grounding:
▶ The unit is equipped with a mains cable with grounding conductor and a plug with grounding pin. The plug must be plugged into a suitable socket, which is installed and grounded according to  local regulations and ordinances and is protected by a FI protection switch (GFCI).
▶ Do not modify the plug. Have a suitable socket installed by an electrician if the plug does not fit into the socket.
▶ Contact an electrician if you have any doubts as to whether the appliance is properly grounded.

Intended use

Only use the product described in this manual as follows:

• As a water feature for permanent installation in ponds or water vessels.
• For use in swimming ponds if the national regulations for installers are met.
• Only operate with the original power pack.
• In compliance with the technical specifications. (→ Technical data)
• Only subject to adherence to the permissible water quality values. (→ Permissible water values

The following restrictions apply to the unit:

• Never use the unit with fluids other than water.
• Never run the unit without water.
• Do not use in conjunction with chemicals, foodstuff, easily flammable or explosive substances.• Do not use for commercial or industrial purposes.
• According to EMC (Electromagnetic Compatibility), this is a class A unit. The unit may cause malfunctions in living environments. It is the user’s responsibility to take suitable countermeasures.

Product description

The Water Jet Lightning is a remote-controlled water feature consisting of two illuminated water arches.
Overview

• If only one Water Jet Lightning is connected, this connector must be plugged into the free port.
12| Weather protection hood
• The protection hood must always be in place during operation.
13| Switching power pack with power plug
14| Hand-held transmitter (including battery type CR 2032)

Symbols on the unit

Read the operating manual prior to using the unit.

Installation and connection

Installation planning

• The water features can be installed submerged and are also suitable for dry installation.
• With submerged installation, the nozzle must protrude at least 3.2 in (8 cm) from the water.
• Operate the pump only when it is covered with at least 4 in (10 cm) of water. Otherwise, it may draw air.

Fitting the water feature

• Mount the unit on a firm ground, e.g. sidewalk slab. (The assembly material is not included in the scope of delivery.)
• Ensure a safe, horizontal position.

Fitting the pump
NOTE
If the pump is used for conveying excessively muddy water, the impeller unit will be subject to increased wear and will require earlier replacement.
▶ Thoroughly clean the pond or pool before installing the pump.
▶  Install the pump at a raised level above the bottom of the pond. This reduces intake of muddy water.

• Install the pump housing horizontally on a firm, mud-free surface. Ensure that the pump housing is securely positioned.
• Operate the pump only when it is covered with at least 4 in (10 cm) of water. Otherwise, it maydraw air.

Connecting the hose

• For optimal water arches, we recommend hose lengths between 6.6 and 9.8 ft (2 and 3 m).

Fitting the control box

• Position the control box and the power pack protected from direct sunlight. The distance to the water must be more than 6.6 ft (2 m).
• If the ground is soft, the control box can be anchored to the ground with a ground stake.
• Alternatively, the control box can be attached to a plate with suitable screw connectors. (Thescrews are not included in the scope of delivery.)

Establishing the connections
WARNING
The power supply carries dangerous electrical voltage and must not be placed directly near water. Otherwise, there is a risk of serious injury or death from electric shock.
▶ Install the power supply in a flood-protected position at a distance of at least 6.6 ft (2 m) from the water.

**** If only one Water Jet Lightning is to be connected, the free connection on the control box must be terminated with the jumper plug.

Commissioning/start-up

NOTE
Never connect the control box to a dimmer. This will destroy the control box.
NOTE
Never allow the pump to run dry. This will destroy the pump.
▶  Only operate the pump when it is submerged or flooded.

Switching ON/OFF

• Switching on: Plug the power plug into the outlet.
  – The unit switches on immediately.

• Switching off: Pull the power plug from the outlet.

Setting the water feature

Operation

The control box is operated by radio via a 2-channel hand-held transmitter. The hand-held transmitter has a range of max. 260 ft (80 m). Obstacles between hand-held transmitter and control box, a low battery in the hand-held transmitter or electro-magnetic radiation of electrical equipment will impair the range. When the control box is switched on (power plug inserted), the hand-held transmitter can be used to sequentially select 4 pre-programmed water feature images. After switching on the unit, program 1 is automatically activated.

• Button 1: Selecting the next program.
• Button 2: Selecting the previous program.

Programs

• Press buttons 1 and 2 simultaneously to set the current color permanently.
• Press buttons 1 and 2 simultaneously again to set the light change.
P3| Pulsating water jet, continuous white light
P4| Pulsating water jet, colored light change/colored continuous light
• Press buttons 1 and 2 simultaneously to set the current color permanently.
• Press buttons 1 and 2 simultaneously again to set the light change.

Teach-in hand-held transmitter
The hand-held transmitter included in the scope of delivery is taught in for the control box. A maximum of 10 hand-held transmitters can be set to the control box.
If you want to register another hand-held transmitter to the control box, proceed as follows:

Teach-in hand-held transmitter:

1. Press the teach-in button on the control box with a pointed object (pen, bent paper clip, etc.) for approx. 1 second. The control box is now in teach-in mode for 3 seconds.
2. Press any button on the hand-held transmitter for approx. 1 second within the 3 seconds. The control box can now be operated with the new hand-held transmitter.

****You can only log out all hand-held transmitters known to the control box together, not individual ones. To log out all hand-held transmitters, press the teach-in button for approx. 5 seconds.

Maintenance and cleaning

NOTE
Do not use aggressive cleaning agents or chemical solutions. These agents can damage the housing, impair the function of the device and harm animals, plants and the environment.
▶ Clean the unit with clean water and a soft brush or sponge wherever possible. Remove stubborn dirt with the aid of the recommended cleaning agents.
Cleaning the unit
****Clean the unit as required, but at least twice a year.

• Recommended cleaning agent for removing stubborn limescale deposits:
  – Vinegar- and chlorine-free household cleaning agent.

• After cleaning, thoroughly rinse all parts in clean water.

Disassemble the water feature

• Pull the power plug and remove all connections.
• Dismantle the unit as shown in the figure.

Disassemble the pump

• Pull the power plug and remove all connections.
• Dismantle the unit as shown in the figure.

Changing the battery
NOTE
Electrical components can be destroyed by static discharge or moisture.

• Avoid touching electrical components or conductors. If this is unavoidable, discharge yourself from static charge beforehand by grounding yourself briefly, for example, on a bare heating pipe.
• Protect the interior of the housing from dirt and moisture.

Storage/overwintering

Remove the Water Jet components at temperatures below zero degrees centigrade.

• Before storage, perform a thorough cleaning, check all components for damage.
• Store the Water Jets and pump frost-free and immersed in a container filled with water. Do not immerse the plugs.

Troubleshooting

• Check supply lines
The hand-held transmitter does not transmit| • Insert a new battery
• Teach-in hand-held transmitter
LED not lit| Connection of the Water Jets faulty| Check connections
Insufficient fountain height| The running unit device is clogged or soiled| Clean the running unit
Pump strainer casing soiled| Clean strainer casing
Nozzles soiled| Clean the nozzles
Foam filters soiled| Wash out foam filters
Hose kinked| Lay hose in a sufficiently large bend
Y distributor clogged| Clean Y distributor
Regulator on Y-distributor incorrectly set| Adjust regulator
Unit switches off after a brief running time (approx. 10s)| Water temperature too high| Note maximum water temperature of + 95 °F (+35°C). For switching on again, pull the power plug and reinsert in the socket.
Pumps run dry| Check water level. For switching on again, pull the power plug and reinsert in the socket.

Technical data

Switching power pac

| | | 100 VA / 12 V DC
---|---|---|---
Primary| Mains voltage| V AC| 120
Power frequency| Hz| 50/60
Max. power consumption| W| 110
Cable length| ft| 6.6
m| 2
Secondary| Output voltage| V DC| 12
Max. output current| A| 8.5
Cable length| ft| 1.6
m| 0.5
Protection type| IP44
Protection class| II
Ambient temperature| °F| +14 … +95
°C| -10 … +35
Dimensions (L × W × H)| in| 9.1 × 5.8 × 2.7
mm| 231 × 148 × 68
Weight| lbs| 5.1
kg| 2.3

Water Jet Lightning

Permissible water values

| | Fresh water, pond water
---|---|---
pH value| | 6.8 … 8.5
Hardness| ppm| 0.45 … 0.84
°dH| 8 … 15
Free chlorine| moz/gal| <0.04
mg/l| <0.3
Chloride content| moz/gal| <33.4
mg/l| <250
Salt content| %| <0.4
Overall dry residue| moz/gal| <6.67
mg/l| <50
Temperature| °F| +39 … +77
°C| +4 … +35

Wear parts

• Impeller unit
• Bulbs

Disposal

NOTE
Do not dispose of this unit with domestic waste.

• Dispose of the unit by using the return system provided for this purpose.
• Should you have questions, please contact your local disposal company. They will give you instructions on how to dispose of your unit properly.
• Disable the unit by cutting off the cables.

NOTE
Disposal of batteries
Do not dispose of batteries with household waste.

• Only dispose of dead batteries by using the return system provided for this purpose.

Disposal of batteries within the European Union
As a user, you are obligated by law to return used batteries. Return is free of charge.

• Return batteries to the point of sale or dispose of batteries through the public take-back and recycling systems in your city or municipality.

Labeling of batteries containing harmful substances
PB = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
Li = Battery contains lithium

OASE North America Inc.
125 Lena Drive | Aurora
Ohio 44202 | USA
customercare@oase.com
www.atlantic-oase.com
12751/03-23

Documents / Resources

| Oase 50355 Water Jet Lightning [pdf] Instruction Manual
50355, 50355 Water Jet Lightning, Water Jet Lightning, Jet Lightning, Lightning
---|---

References

• OASE Consumer
• Home | Atlantic Water Gardens
• Home | Atlantic Water Gardens

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>