Danfoss PVG32 LS Pressure Relief Valve Installation Guide
- June 1, 2024
- Danfoss
Table of Contents
Danfoss PVG32 LS Pressure Relief Valve ****
Product Description
| Across flats | Max. Tightening torque |
|---|---|
| 24 mm [0.94 in] | 45 Nm [400 lbf•in] |
| Max operation pressure | 350 bar [5075 psi] |
| --- | --- |
| Max. coil surface temperature | 155°C [302°F] |
| Rated voltage | 12 V |
| Current consumption | 22°C coil temperature |
| 110°C coil temperature | 1 A |
| 22°C coil temperature | 19 W |
| 110°C coil temperature | 12 W |
| Max. permissible deviation from rated supply voltage | ±10% |
Connection
When installing the wire remember to connect the built-in diode to the plug pins.
AMP plug connection
The AMP plug contains no integrated diode. PVPX control circuit protection must thus be installed externally, possible by means of a (36V suppressor diode, BZW04) in the terminal block.
Danfoss can accept no responsibility for possible errors in catalogues,
brochures and other printed material. Danfoss reserves the right to alter its
products without notice. This also applies to products already on order
provided that such alterations can be made without changes being necessary in
specifications already agreed.
All trademarks in this material are property of the respective companies.
Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights
reserved.
