YUER TR-U1 Digital Wireless Transmitter and Receiver Owner’s Manual
- June 3, 2024
- YUER
Table of Contents
YUER TR-U1 Digital Wireless Transmitter and Receiver
IMPORTANT NOTES
- Do not disassemble or repair this product by yourself.
- Do not use or store it to any heat sources, damp, dusty areas . Avoid violent vibrations or shock
- Do not drop this product otherwise it may malfunction.
- Do not use alcohol or other cleaning fluids to clean this product.
- This product works normally only when the transmitter and the receiver pairs up. It supports one-to-one and one-to-many.
- Please make sure the transmitter and the receiver keep a distance away from wireless router or other wireless equipment’s during use.
- Obstructions between the transmitter and the receiver may affect the transmission distance.
- A maximum of 4 sets of transmitters and receivers can be used in the same place simultaneously.
- If the red indicator flickers during use . it indicates low battery, please charge it in time.
- Please turn off the transmitter and the receiver when not in use.
- Due to one of the characteristics of lithium battery, there is a slight self-discharge. Therefore please charge the battery in 2 months so as to avoid low battery protection.
- The lithium battery capacity decreases gradually after repeated charge and discharge, so this products lifetime will be affected within acceptable degree with time.
PARAMETERS
- 48K / 24bit audio resolution
- Delay time: < 5ms
- Transmission distance> 20m
- Frequency response: 1 0HZ-22 KHZ+ -1 dB
- Distortion:< 0. 02 % (@ 1 KHZ-1 0dBFS)
- Wireless frequency band: 2. 4GHZ ISM frequency band
- Anti-interference method: Frequency hopping
- Quantity of signal channel: 12, in 4 channel banks
- Built-in lithium battery: Over 10 hrs battery life once fully charged
Specifications
Battery: Rechargeable lithium battery 3. 7 / V / 65 0 mAh Frequency
response : 1 0HZ-22KHZ
Wireless frequency band: 2. 4GHZ ISM frequency band Volume: 73x35x30mm (
when being folded )
Attached accessories: Owner’s manual, USB cable
How to use
- How to charge the transmitter and the receiver? When the red indicator starts flickering, it indicates low battery ,and please charge it in time.
The red indicators are on during charging . They go off once fully charged
- The double-sided USB cable can charge the transmitter and receiver simultaneously.
2. Connect the transmitter to the guitar
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>