YUER Waterproof 18x18W RGBWA UV 6 in1 LED Wash Washer User Manual

YUER Waterproof 18x18W RGBWA UV 6 in1 LED Wash Washer

Thank you very much for choosing our product. For safety purpose, please read this manual carefully before your operation. This manual included installation and using information. Please install and operate it according to this manual.

PRODUCT

Product introduction

The LED wash lighting Suitable applications include wash or effect lighting for architectural, stage or nightclub applications. This product can also be installed for use in signage and advertising using the dynamic functions available with DMX512 control. Direct input of DMX512 signal allows the units to be controlled from any DMX512 controller. This product can be operated as a single unit or in multiple units for large applications.

Technical Specifications

• Voltage: AC100-240V, 50/60Hz
• Power: 200W
• Light Source : 18PCS *18W （ RGBWA+UV 6in1 LED）
• IP Rating : IP20
• Lifespan: around 80,000 hours
• Housing: Die-casting aluminum, powder-coated finish
• Control: DMX 512, 3modes (6/10/108CH)
• Control Mode: DMX, Auto, Master/Slave, Sound active
• Dimmer: 0-100%
• Strobe: 0-20Hz
• Beam angle: 15º

Safety Warning

IMPORTANT:

ALWAYS READ THE USER MANUAL BEFORE OPERATION. PLEASE CONFIRM THAT THE POWER SUPPLY STATED ON THE PRODUCT IS THE SAME AS THE MAINS POWER SUPPLY IN YOUR AREA.

• This product must be installed by a qualified professional.
• Always operate the equipment as described in the user manual.
• A minimum distance of 0.5m must be maintained between the equipment and combustible surface.
• The product must always be placed in a well ventilated area.
• Always make sure that the equipment is installed securely.
• DO NOT stand close to the equipment and stare directly into the LED light source.
•  Always disconnect the power supply before attempting and maintenance.
• Always make sure that the supporting structure is solid and can support the combined weight of the products.
• The earth wire must always be connected to the ground.
• Do not touch the power cables if your hands are wet.

ATTENTION:

• This product left the place of manufacture in perfect condition. In order to maintain this condition and for safe operation, the user must always follow the instructions and safety warnings described in this user manual.
• Avoid shaking or strong impacts to any part of the equipment.
• Make sure that all parts of the equipment are kept clean and free of dust.
• Always make sure that the power connections are connected correct and secure.
• If there is any malfunction of the equipment, contact your distributor immediately.
• When transferring the product, it is advisable to use the original packaging in which the product left the factory.
• Shields, lenses or ultraviolet screens shall be changed if they have become damaged to such an extent that their effectiveness is impaired.
• The lamp (LED) shall be changed if it has become damaged or thermally deformed.

Mounting

Hanging

The product can be mounted in a hanging position using the supporting bracket. The bracket should be secured to the mounting truss or structure using a standard mounting clamp. Please note that when hanging the unit a safety cable should also be used.

Upright

The product can be mounted in an upright or sitting position using the supporting brackets.
NOTE: The product can be mounted at any angle and in any position. It is possible to further adjust the angle of the product using the two adjustment knobs located on the side of the fixture.

DMX Channel instruction

STAG MODE

3

| Color Macro| 0-255| mode effect.
Channel value| Mode code| effect
0-1| 0| inaction
2-3| 1| red lamp.
4-5| 2| green light.
6-7| 3| blue light.
8-9| 4| white lamp.
10-11| 5| yellow light.
 | 12-13| 6| purple lamp.
---|---|---|---
 | 14-15| 7| red and blue stained light.
16-17| 8| Comprehensive 1-7 effect cycle.
18-19| 9| gradual change
20-21| 10| Pulse change
22-23| 11| A red light for horse-racing.
24-25| 12| A green light for horse-racing.
26-27| 13| A blue light for horse racing.
28-29| 14| A white light is running on a horse.
30-31| 15| A yellow light for horse-racing.
32-33| 16| A red and blue stained lantern for horse running.
34-35| 17| A green and blue stained lantern for horse running..
36-37| 18| Comprehensive 11-17 effect cycle.
38-39| 19| Two red lights are running on the horses.
40-41| 20| Two green lights are running on horses.
42-43| 21| Two blue lights for horse racing.
44-45| 22| Two white lights are running on the horses.
46-47| 23| Two yellow lights for horse racing.
48-49| 24| Two red and blue stained lights are racing.
50-51| 25| Two green and blue stained lights are racing.
52-53| 26| Comprehensive 19-25 effect cycle.
54-55| 27| Three red lights run on horses.
56-57| 28| Three green lights are horse-racing.
58-59| 29| Three blue lights to run on the horses.
60-61| 30| Three white lights to run on horses.
62-63| 31| Three yellow lights to run on horses.
64-65| 32| Three red and blue stained lights are horse racing.
66-67| 33| Three green and blue stained lights are racing.
68-69| 34| Comprehensive 27-33 effect cycle.
 | 70-71| 35| A red light to refresh.
---|---|---|---
72-73| 36| A green light to refresh.
74-75| 37| A blue light to refresh.
76-77| 38| A white light to refresh.
78-79| 39| A yellow light to refresh.
80-81| 40| A red and blue stained light to refresh.
82-83| 41| A green and blue stained light to refresh.
84-85| 42| Comprehensive 35-41 effect cycle.
86-87| 43| Two red lights to refresh.
88-89| 44| Two green lights to refresh.
90-91| 45| Two blue lights to refresh.
92-93| 46| Two white lights to refresh.
94-95| 47| Two yellow lights to refresh.
96-97| 48| Two red and blue stained lights to refresh.
98-99| 49| Two green and blue stained lights to refresh.
100-101| 50| Comprehensive 43-49 effect cycle.
102-103| 51| A red light ran back and forth.
104-105| 52| A green light runs back and forth.
106-107| 53| A blue light ran back and forth.
108-109| 54| A white light ran back and forth.
110-111| 55| A yellow light ran back and forth.
112-113| 56| A red and blue-stained light ran back and forth.
114-115| 57| A green and blue-stained lamp ran back and forth.
116-117| 58| Comprehensive 51-57 effect cycle.
118-119| 59| Two red lights run back and forth.
120-121| 60| Two green lights run back and forth.
122-123| 61| Two blue lights ran back and forth.
124-125| 62| Two white lights run back and forth.
126-127| 63| Two yellow lights run back and forth.
128-129| 64| Two red and blue stained lights run back and
 |  |  | forth.
---|---|---|---
130-131| 65| Two green and blue-stained lights run back and forth.
132-133| 66| Comprehensive 59-65 effect cycle.
134-135| 67| One red lamp at each end runs back and forth.
136-137| 68| One green lamp at each end runs back and forth.
138-139| 69| One blue lamp at each end runs back and forth.
140-141| 70| A white lamp at each end runs back and forth.
142-143| 71| A yellow light at each end runs back and forth.
144-145| 72| One red and blue stained lamp at each end runs back and forth.
146-147| 73| One green and blue-stained lamp at each end runs back and forth.
148-149| 74| Comprehensive 67-73 effect cycle.
150-151| 75| Two red lights at each head are running back and forth.
152-153| 76| Two green lights at each head run back and forth.
154-155| 77| Two blue lights at each end ran back and forth.
156-157| 78| Two white lights at each end run back and forth.
158-159| 79| Two yellow lights at each end run back and forth.
160-161| 80| Two red and blue stained lights at each end run back and forth.
162-163| 81| Two green and blue stained lights at each end run back and forth.
164-165| 82| Comprehensive 75-81 effect cycle.
166-167| 83| A red light tail.
168-169| 84| A green light tail.
170-171| 85| A blue light tail.
172-173| 86| A white light tail.
 | 174-175| 87| A yellow light tail.
---|---|---|---
176-177| 88| A red and blue-stained lamp tail.
178-179| 89| A green-blue stained lamp tail.
180-181| 90| Comprehensive 83-89 effect cycle.
182-183| 91| A red light horse running has a residual shadow.
184-185| 92| A green light horse running has a residual shadow.
186-187| 93| A blue light horse running has a residual shadow.
188-189| 94| A white light horse running has a residual shadow.
190-191| 95| A yellow light has a shadow.
192-193| 96| A red and blue stained lamp has a shadow.
194-195| 97| A green and blue stained lamp has a shadow.
196-197| 98| Comprehensive 91-97 effect cycle.
198-199| 99| Two red light pendulum.
200-201| 100| Two green light pendulum.
202-203| 101| Two blue light pendulum.
204-205| 102| Two white light pendulum.
206-207| 103| Two yellow light pendulum.
208-209| 104| Two red and blue stained light pendulum.
210-211| 105| Two green and blue stained light pendulum.
212-213| 106| Comprehensive 99-105 effect cycle.
214-215| 107| A red light was piled up.
216-217| 108| A green light was piled up.
218-219| 109| A blue light was piled up.
220-221| 110| A white light was piled up.
222-223| 111| A yellow light piled up.
224-225| 112| A red and blue-stained lamp accumulates.
226-227| 113| A green and blue-stained lamp was piled up.
228-229| 114| Comprehensive 107-113 effect cycle.
230-231| 115| Red waves.
 | 232-233| 116| Green waves.
---|---|---|---
234-235| 117| Blue waves.
236-237| 118| White waves.
238-239| 119| Yellow waves.
240-241| 120| Red and blue-stained waves.
242-243| 121| Green-blue stained waves.
244-245| 122| Comprehensive 115-121 effect cycle.
246-247| 123| Colorful water.
248-249| 124| Colorful refresh, from the middle to the two sides, one side of one color.
250-251| 125| Colorful from the middle to both sides

of the color selection refresh.

252-253| 126| Colorful refresh, refresh on one color to another color.
254-255| 127| Mode code: 11-126 cycle.
4| Auto speed| 0-255| Auto speed adjustment
5| Red| 0-255|
6| Green| 0-255|
7| Blue| 0-255|
8| White| 0-255|
9| Amber| 0-255|
10| UV| 0-255|
108CH| Function| DMX Value|
---|---|---|---
1| Red| 0-255| The first red lamp bead is a linear dimmer.
2| Green| 0-255| The first green lamp bead is a linear dimmer.
3| Blue| 0-255| The first blue lamp bead is a linear dimmer.
4| White| 0-255| The first whit lamp bead is a linear dimmer.
5| Amber| 0-255| The first amber lamp bead is a linear dimmer
6| UV| 0-255| The first UV lamp bead is a linear dimmer.
……….| ……….| ……….|
103| Red| 0-255| The 18th red lamp bead is a linear dimmer.
104| Green| 0-255| The 18th green lamp bead is a linear dimmer.
105| Blue| 0-255| The 18th blue lamp bead has a linear dimming
106| White| 0-255| The 18th white lamp bead is a linear dimmer.
107| Amber| 0-255| The 18th amber lamp bead is a linear dimmer.
---|---|---|---
108| UV| 0-255| The 18th UV lamp bead is a linear dimmer.

Special construction for DMX connection

• At last fixture, the DMX cable has to be terminated with a terminator to reduce signal errors. Solder a 120-ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX output of the last fixture.
• If the controller is 5-pin output, it is necessary to use an adaptor to transfer the signal from 5-pin output to 3-pin XLR-plug or you can connect cables as follows:

Display Panel Operation

Display panel menu instruction

• [MODE] menu selection or return to the previous menu.
• [UP] press [UP] through the menu list to increase/change the value of the current function.
• [DOWN] press [DOWN] through the menu list to decrease/change the value of the current function.
• [ENTER] confirm & quit out the current function setting.

Display Menu instruction (general)

Maintenance

• Clean with soft cloth using normal glass cleaning fluid.
• Always dry the parts carefully.
• Clean the external optics at least every 20 days.
• Clean the internal optics at least every 30/60 days – Up to vary products.

Please ask professional technical to clean waterproof products and make sure the fixture will be reassembled well for waterproof.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>