GLIDEROL TM-390 Remote Control Instructions
- June 1, 2024
- GLIDEROL
Table of Contents
GLIDEROL TM-390 Remote Control
PRODUCT INFORMATION
SPECIFICATIONS
- Gliderol Frequency: 390Mhz
- Buttons: 3
- Battery: CR2016
PRODUCT USAGE INSTRUCTIONS
Remote Programming Steps
- Press and hold the `Enter’ button for 2 seconds to access the operator menu. The unit will beep twice to confirm this has been selected.
- Use the arrow (Up & Down) buttons to select the
Learn’ option and pressEnter’ to confirm selection. The unit will beep three times to confirm the unit is in `Learn’ mode. - Press the `Large’ button on the handset. The unit will beep twice to confirm successful coding. Wait approximately 3 seconds for the unit to exit setup mode. (Always use the large button for coding, even if configured to use small buttons for normal operation.)
Deleting All Remote Controls from Receiver
- Pressing the enter button for 5 seconds or more will erase all handset data from your receiver (garage door motor).
RECEIVER COMPATIBILITY
Glidermatic GTS Optima, Glidermatic GRD+, Glidermatic GRD Dual &
Glidermatic IGDU
FAQ
-
Can I program multiple remotes to the receiver?
Yes, you can program multiple remotes by following the Remote Programming Steps mentioned above for each additional remote. -
How do I know if the remote programming was successful?
If the unit beeps twice after pressing the `Large’ button during programming, it confirms successful coding. -
What should I do if my remote stops working?
Try replacing the battery with a new CR2016 battery. If the issue persists, follow the Remote Programming Steps to reprogram the remote to the receiver.
GLIDEROL
REMOTE ORDERING OPTIONS
SPECIFICATIONS
- Gliderol
- Frequency – 390Mhz
- Buttons – 3
- Battery – CR2016
COMPATIBLE WITH
- RECEIVER COMPATIBILITY
- Suits Models:
- Glidermatic GTS Optima, Glidermatic GRD+, Glidermatic GRD Dual & Glidermatic IGDU
Remote Programming Steps
Programming New Remotes to Receiver
- Press and hold the ‘Enter’ button for 2 seconds to access the operator menu. The unit will beep twice to confirm this has been selected.
- Use the arrow (Up & Down) buttons to select the ‘Learn’ option and press ‘Enter’ to confirm selection. The unit will beep three times to confirm the unit is in ‘Learn’ mode.
- Press the ‘Large’ button on the handset. The unit will beep twice to confirm successful coding. Wait approx 3 seconds for the unit to exit setup mode. (Always use the large button for coding, even if configured to use small buttons for normal operation.)
Deleting All Remote Controls from Receiver
- Pressing the enter button for 5 seconds or more will erase all handset data from your receiver (garage door motor.)
Whilst every effort has been made to ensure the accuracy of the information supplied herein, we assume no liability for any errors or omissions. Information contained in this document is subject to change without prior notice.