GLIDEROL Single Button Handset TM-27 Instruction Manual
- June 6, 2024
- GLIDEROL
Table of Contents
TM-27 Single Button Handset
Programming New or Additional Handsets
The following instructions demonstrate how to program a new or additional
Gliderol Single Button Handset to suit most Gliderol operators pre-1998. Older
Gliderol units operate using either Trinary or Binary coding. Trinary units
will have a 9 digit code shown inside the operator Control Box, whereas Binary
units will have two 8 digit codes inside their Control Box. Please refer to
the appropriate set of instructions to successfully program your new Gliderol
Single Button Handset.
Trinary Handset Coding – 9 digit code
|
---|---
Remove the cover from the handset to expose the handset circuit board.| Push
the numbered switches ‘up’ or ‘down’ to reflect the same code shown inside your
existing control box.
Your handset programming is now complete!
Should you require further assistance in programming your Gliderol Single Button Handset please contact your local Gliderol offce on 1300 799 177.
WARNING
To prevent possible SERIOUS INJURY or DEATH:
– Battery is hazardous: NEVER allow children near batteries.
– If the battery is swallowed, immediately notify a doctor. To reduce risk of
fire, explosion, or chemical burn:
– Replace ONLY with the same size and type battery
– DO NOT recharge, disassemble, heat above 100° C, or incinerate Battery will
cause SEVERE or FATAL injuries in 2 hours or less if swallowed or placed
inside any part of the body.
The following instructions demonstrate how to program a new or additional Gliderol Single Button Handset to suit most Gliderol operators pre-1998. Older Gliderol units operate using either Trinary or Binary coding. Trinary units will have a 9 digit code shown inside the operator Control Box, whereas Binary units will have two 8 digit codes inside their Control Box. Please refer to the appropriate set of instructions to successfully program your new Gliderol Single Button Handset.
Binary Handset Coding – 16 digit code (2 x 8 digit codes)
| BINARY SWITCH A | UP | UP | DOWN | DOWN |
|---|---|---|---|---|
| BINARY SWITCH B | UP | DOWN | UP | DOWN |
| HANDSET (TRINARY) SWITCH | DOWN | UP | MIDDLE | MIDDLE |
Step 1:
Fill out the below table using both of the 8 digit codes inside your control
box. Identify if the switch is in the ‘UP’ or ‘DOWN’ position.
Step 2:
Using the information collected in Step 1, use the ‘Binary to Trinary
Conversion Table’ to determine your new handset code. Please note, these
numbers are not in sequence (eg the second digit in your handset code is the
result of the third digits from your control box code). The ninth digit is
always in the ‘DOWN’ position.
Handset Code
Using your new ‘Handset Code’, follow the ‘Trinary Handset Coding’ instructions to complete your Handset programming.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>