CLV B04-21RXQD-C-E LCD RGB Wall Washer Instruction Manual
- June 1, 2024
- CLV
Table of Contents
CLV B04-21RXQD-C-E LCD RGB Wall Washer
Thank you for purchasing a product. To ensure a better shopping experience,
please follow the instructions for use step by step. If you have any questions
about our products, please contact our customer service, our after-sales team
will contact you the first time and resolve any problems with the products.
E-mail: clysales01@clytools.com
service@clv-ledlight.com
Warning
- The LED module can’t be replaced, you need to replace the entire lamp if it is damaged or reaches the service life.
- If the wire is damaged, the lamp can no longer be used and needs to be scrapped.
- If the casing breaks or water enters, the lamp can no longer be used and needs to be scrapped.
- Do not stare at the LED light-emitting surface closely for a long time, to prevent the hurt of the eye.
- Under no circumstances should the luminaire be covered by a thermal pad or similar material.
- The Lamp requires a professional electrician to install.
- The P66 waterproof grade is just for rainproof, the lamp can not be immersed in water, otherwise it may cause leakage.
Component and structure diagrams
Parameter
How to install
Step 1: Install the bracket on the lamp body with screws.
Step 2: Drill two mounting holes in the wall or on the ground according to the distance of the screw holes on the bracket.
Step 3: Place the bracket on the prepared mounting hole and fix it with
screws and adjust the angle.
Step 4: Insert the plug into the power outlet and turn on the power to
ensure that the product is working properly, install batteries in the remote
and then you can adjust it to your preferred mode.
Warning
- The floodlight has a built-in RF receiver.
- The remote control could control the product within 12 meters.
- Please replace the remote control battery if the the remote control is not sensitive or the control distance becomes shorter be the battery exhausted).
Functions
Memory Function: Lighting colour remains as the previous setting when turned on again.
Romato Control
OFF: Turn off
ON: Turn on
Brightness Up:6 levels of brightness (25%-40%-55%-70%-85%-100%)
Brightness Down:6 levels of brightness (100%-85%-70%-55%-40%-25%)
R R: Red
G) G: Green
B B: Blue
W W: White
FLASH fast jump mode (R + G + B), press to adjust the jump speed
(SMOOTH 2H 4H 6H SMOOTH slow gradual change mode (colourful), press to adjust
the gradual change in speed
2H / 4H / 6H Timing function: Press the 2H / 4H
6H key in any mode, indicating that the light will automatically turn off
after the light works
2 hours/4 hours/6 hours. ( Flash 2 times after Press the timing keys means it
starts timing)
Trouble Clearing
If the product does not work, please confirm whether it is caused by the following reasons.
- The floodlight does not turn on after turning on the power. Please make sure the remote control is aimed at the light, then press “ON”.
- The input voltage does not match the product. Please let a professional electrical check whether the power supply voltage meets the voltage requirements of the light.
- If you still can’t solve the problem according to the instructions, please stop using it and contact an electrical professional or directly contact customer service to get assistance.
Routine maintenance
- Please clean the light regularly to ensure the product works well.
- Please make sure the power is off before maintenance.
- Please do not clean it with chemicals to avoid damage to the lamp.
http://www.clv-ledlight.com
E-mail:clysales01@clytools.com
E-mail: service@clv-ledlight.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>