DOMUS Dusk MR11 LED Garden Spike Light Instruction Manual
- June 1, 2024
- DOMUS
Table of Contents
Installation Manual
Date: December 14, 2023 1:22 PM
DUSK SPIKE MR11
Specifications
| Voltage: | 12V DC | Lumen (±5%): | Warm White 3000K – 230lm |
|---|---|---|---|
| Power: | 3W | Beam Angle: | 38° |
| IP Rating: | IP65 | CCT: | 3000K |
| CRI: | ≥80 | Lifespan: | 35,000hrs |
| Dimmable: | No | ||
| Requires: | 12V DC Constant Voltage LED Driver (Wire in Parallel) |
Save these instructions
Warning – To reduce the risk of fire or injury to persons:
- Turn power off or unplug the luminaire and allow it to cool before replacing the lamp
- Lamp gets hot quickly. Contact only switch/plug when turning on.
- Do not touch the hot lens, guard or luminaire housing until it has cooled
- Keep Lamp away from combustibles.
- Do not touch lamp. Use a soft cloth. Oil from skin may damage lamp.
- Do no operate the luminaire fitting with a missing or damaged shield.
Important Safety Instructions
- For outdoor use only
- Make sure the power is turned off before installing or servicing the luminaire.
- WARNING: Risk of electrical shock. Install all luminaires 3.05m or more from a pool, spa or fountain.
- Position the wire and wire connector so that it is connected within 15.2 cm from a building or structure, a luminaire or fitting.
- Not to be buried except for a maximum of 15.2cm to connect to the main low voltage cable.
Lamp Installation/Replacement Instructions
- Unscrew the shroud from the fixture housing.
- Insert the MR11 lamp with correct wattage as marked on the fixture label.
- Replace shroud and twist shroud in place.
Fixture Mounting Instructions
- Disconnect transformer from main power supply.
- Remove shroud from the fixture housing
- Insert MR11 LED Lamp (10W max) into the lamp socket.
- Replace shroud and secure with twisting motion
- Run lead wire from the fixture through the ground stake mounting hole.
- Insert composite ground stake in desired location until flange of stake is flush to grade.
- Screw fixture into top of stake and tighten until snug.
- Strip the two fixture lead wires and connect them to the main low voltage supply cable lead with silicone filled wire connectors.
Note:
- The lamp must be installed by professional electrician
- Ensure the power supply is switched off before fitting this product
- Do not touch the lamp when in use
- Keep away from hot steam and corrosive gas
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
enquiries@domuslighting.com.au |
www.domuslighting.com.au
Documents / Resources
|
DOMUS Dusk MR11 LED Garden Spike
Light
[pdf] Instruction Manual
Dusk MR11 LED Garden Spike Light, Dusk MR11, LED Garden Spike Light, Garden
Spike Light, Spike Light, Light
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>