DOMUS 19809 ALPHA-SM Exterior Ceiling Mounted Light Owner’s Manual
- October 30, 2023
- DOMUS
Table of Contents
ALPHA-SM
Installation Manual
19809 ALPHA-SM Exterior Ceiling Mounted Light
| Variants | Item No. | Colour Temp |
|---|---|---|
| Blk | A/u | Wht |
| 19809 | 19413 | 19812 |
| 19810 | 19414 | 19813 |
| 19808 | 19415 | 19811 |
Description: Square body exterior surface mounted ceiling light
Thank you for purchasing your new LED ALPHA-SM Wall Light, Please take the
time to read and understand the instruction sheet below. Failure to do so may
void warranty.
Specifications
Voltage:| 240V AC| Lumen (±5%):| Warm White 3000K (450Im) White 5000K (500Im)|
Dimmable:| Yes
---|---|---|---|---|---
Power:| 6W| Beam Angle:| 60°| Operating Temp:| -20° – 65°
IP Rating:| 65| Ca:| 3000K – 5000K| Lifespan:| 40,000hrs
CRI:| aS0| | | |
Steps:
- Please make a visual inspection to the fixture prior to installation. If any defect is to be found please return to you place of purchase for a replacement.
- Make sure all power is correctly turned off from the mains and NOT just from the switch.
- Unscrew the lamp cover from the main body. Carefully insert the supplied lamp ensuring the pins line up before securing into place.
- Ensure the silicon gasket is in place. Please do not over tighten as this may damage the gasket and inhibit correct IP protection.
- Once lamp has been installed please remove the base mounting plate. Carefully unscrew the three (3) stainless steel grub screws.
- Mount mounting base plate using supplied screws. Please note that due to different mounting sub straights additional fixing screws maybe needed (Not supplied).
- Proceed in connecting the power cable to the supplied terminal block. Due to the nature of this fixture the Earth wire MUST be connected. Please ensure the grommet supplied on the rear base plate is still present (removing this will prevent correct IP protection and void warranty)
- Once connections are made please proceed in re-attaching the main body to the mounting plate. Turn mains power back on from the mains and test to make sure all is working.
- To keep the finish maintained and in good appearance the manufacture recommends cleaning the fixture once every 12mnths with clean fresh water and a mild soap. Please rinse well.
Note:
-The lamp must be installed by professional electrician
-Ensure the power supply is switched off before fitting this product
-Do not touch the lamp when in use
-Keep away from hot steam and corrosive gas
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600
Fax: 02 9554 9433
[email protected]
www.domuslighting.com.au
Date:09/2019