LUMUX SLS1000 Surface Wall Luminaire Light Instruction Manual

LUMUX SLS1000 Surface Wall Luminaire Light

Product Specifications

• Model: Surface Mount Luminaire SLS1000 / 1400 / 1500
• Power Cord: Provided
• Alley Key: Provided
• J-Box Type: O (by Others)
• Mounting Plate: Included

Product Usage Instructions

Preparing the Luminaire:

Before installation, ensure you have all the necessary parts for a water-tight installation. Make sure to turn off the power supply at the circuit breaker or fuse box before proceeding.

Step 1 – Get Luminaire and Proper Parts for Installation:

1. Remove Mounting Plate and prepare all parts needed.

Step 2 – Make Wiring Connections:

1. Place Luminaire close to Mounting surface.
2. Run Power Cord through the Plate hole and make electrical connections following the Wire Diagram.

Step 3 – Install Luminaire Mounting Plate:

1. Place the Mounting Plate and align holes to J-Box tap holes.
2. Fasten using the Screws provided by J-Box Manufacturer. Additional mounting screws and anchors may be used if necessary.

Step 4 – Install Surface Mount Luminaire:

1. Push the Power Cord into the J-Box.
2. Align Mounting Plate Taps to Luminaire grooves.
3. Fasten the Set Screws using the Alley Key provided.

Step 5 – Final Installation:

1. Apply silicone around the Luminaire Base and wall surface for a watertight seal in outdoor applications.

FAQ

Q: What should I do if I need replacement parts or additional information?

A: Contact or visit the manufacturer at www.lumux.net for re-lamping, replacement parts, or additional information.

PREPARING THE LUMINAIRE

READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE INSTALLATION. IF YOU ARE NOT FAMILIAR WITH THE NATIONAL ELECTRICAL CODE (NEC), CONTACT A QUALIFIED ELECTRICIAN TO INSTALL THIS LUMINAIRE.

WARNING.- Before installing this luminaire or doing any maintenance, turn off the power supply at the circuit breaker or fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.

NOTE:

To re-lamp, replacement parts or additional information, contact or visit the manufacturer at www.lumux.net

Installation Instruction

Step 1 – Get Luminaire and proper Parts for Installation:

• a.- Remove the Mounting Plate and prepare all parts as needed for water-tight Installation.

Step 2 – Make Wiring Connections:

• a.- Place the Luminaire close to the Mounting surface, run Power Cord through the Plate hole and make electrical connection, see Wire Diagram.

Step 3 – Install Luminaire Mounting Plate:

• a.- Place Mounting Plate and align holes to J-Box tap holes and fasten using the Screws provided by J-Box Manufacturer. Installer may use additional mounting screws and anchors (by others).

Step 4 – Install Surface Mount Luminaire:

• a.- Push the Power Cord into the J-Box and align Mounting Plate Taps to Luminaire grooves “set Screws” and fasten the Set Screws using the Alley Key (provided).

Step 5 – Final Installation:

• a.- It is recommended to apply silicone around the Luminaire Base and wall surface for a watertight seal on Outdoor Applications.

LUMUX – ARCHITECTURAL LIGHTING COMPANY-

• Toll-Free 877- 895-5552
• www.Lumux.net

References

• Lumux Lighting

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>