LUMUX WS-BL700 Surface Wall Ceiling Mount Luminaire Instruction Manual
- May 15, 2024
- LUMUX
Table of Contents
LUMUX WS-BL700 Surface Wall Ceiling Mount Luminaire
Step 1
Disassemble Luminaire Parts for Easy Installation:
Remove the Fixture Mounting Plate and Bracket from the Fixture.
Step 2
Install Mounting Bracket:
Place the Universal Bracket onto the Electrical Box and secure it using two
J-Box Screws (By others).
Step 3
Install Fixture Mounting Base:
- Run Input wires through the centre hole of the Mounting Bracket. and make hard-wire connections, see Wire Diagram.
- Insert the two 8-32 Screws (provided) through the Holes and use the Nuts (provided) to secure the Base on the Mounting Surface.
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE INSTALLATION. IF YOU ARE NOT FAMILIAR WITH THE NATIONAL ELECTRICAL CODE (NEC), CONTACT A QUALIFIED ELECTRICIAN TO INSTALL THIS LUMINAIRE.
WARNING
Before installing this luminaire or doing any maintenance, turn off the power
supply at the circuit breaker or fuse box. Turning the power off using the
light switch is not sufficient to prevent electrical shock.
NOTE
To re-lamp, replacement parts or additional information, contact or visit the
manufacturer at www.lumux.com
Step 4
Replace Fixture LED Plate:
Place the LED Plate on Fixture Base Spacers, align the holes and fasten using
the two Plate Screws (provided)
Step 5
Install Surface Fixture:
Place the Fixture on the Base align the holes and fasten using the four
Mounting Screws (provided).
Step 6
Final Installation:
It is recommended to apply silicone around the Luminaire Base and wall surface
for a watertight seal for Outdoor Applications.
LUMUX – ARCHITECTURAL LIGHTING COMPANY- Toll-Free 877- 895-5552 www.Lumux.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>