LUMUX SL700 Surface Wall Mount Luminaire Instruction Manual
- May 15, 2024
- LUMUX
Table of Contents
LUMUX SL700 Surface Wall Mount Luminaire
Step 1
Disassemble Luminaire Parts for Easy Installation:
- Remove the Mounting Plate from the back of the Luminaire.
Step 2
Install Fixture Mounting Plate:
- Place the Fixture Plate onto the Electrical Box and secure it using two J-Box Screws (By others).
Step 3
Make Wiring Connections:
- Run the Electrical Wires through the Fixture Mounting Plate and make hard-wire connections, see Wire Diagram.
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE INSTALLATION. IF YOU ARE NOT FAMILIAR WITH THE NATIONAL ELECTRICAL CODE (NEC), CONTACT A QUALIFIED ELECTRICIAN TO INSTALL THIS LUMINAIRE. LUMUX ARCHITECTURAL LIGHTING COMPANY- Toll-Free 877- 895-5552 www.Lumux.com
WARNING
Before installing this luminaire or doing any maintenance, turn off the
power supply at the circuit breaker or fuse box. Turning the power off using
the light switch is not sufficient to prevent electrical shock.
NOTE
To re-lamp, replacement parts or additional information, contact or visit the
manufacturer at www.lumux.com
Step 4
Install LED Luminaire:
Place the Luminaire Base on the Surface Plate, align the holes and fasten
using the two Mounting Screws (provided).
Step 5
Final Installation
It is recommended to apply silicone around the Luminaire Base and wall surface
for a watertight seal for Outdoor applications.
LUMUX – ARCHITECTURAL LIGHTING COMPANY- Toll-Free 877- 895-5552
www.Lumux.com