LUMUX WS500 Surface Wall Mounted Units Instruction Manual
- May 15, 2024
- LUMUX
Table of Contents
LUMUX WS500 Surface Wall Mounted Units
Product Information
Specifications:
- Model: WS700, WS800, WS500 Surface Wall Mounted units
- Manufacturer: LUMUX – ARCHITECTURAL LIGHTING COMPANY
- LED Module
- Toll-Free Customer Support: 877-895-5552
- Website: www.lumux.net
Product Usage Instructions
Preparing the Luminaire:
Before installation, make sure to prepare the luminaire following these steps:
- Read and understand all instructions provided in the manual.
- If you are not familiar with the National Electrical Code (NEC), contact a qualified electrician for installation.
LED Module:
To re-lamp, replace parts, or obtain additional information regarding the LED
module, contact the manufacturer:
- LUMUX – ARCHITECTURAL LIGHTING COMPANY
- Toll-Free: 877-895-5552
- Website: www.lumux.net
FAQ
Q: Where can I find replacement parts for the luminaire?
A: For replacement parts or additional information, contact the
manufacturer at the provided toll-free number or visit their website.
Q: Can I install the luminaire myself if I am not familiar with the NEC?
A: It is recommended to contact a qualified electrician for installation
if you are not familiar with the National Electrical Code.
INSTALLATION OPERATION INSTRUCTIONS
PREPARING THE LUMINAIRE
For all WS700, WS800 & WS500 Surface Wall Mounted units
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE INSTALLATION. IF YOU ARE NOT FAMILIAR WITH THE NATIONAL ELECTRICAL CODE (NEC), CONTACT A QUALIFIED ELECTRICIAN TO INSTALL THIS LUMINAIRE.
-
WARNING – Before starting the installation, disconnect the power by turning off the circuit breaker or removing the fuse at the fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
-
If you are replacing an existing fixture, disconnect and remove the old fixture.
Expose the supply wiring from the Outlet-Box. -
Fasten the Universal Mounting Strap (provided) to the Oulet-Box using the two Screws, (by others) as shown in figure below.
-
Make electrical connections: Connect grounding wire (green or bare copper) from the supply circuit to the bare copper wire from the fixture. Connect the white wire from the fixture to the white wire of the supply circuit. Connect the black wire from the fixture to the black wire of the supply circuit. Use U.L. Listed wire connectors (by others). Secure wire connectors with U.L. Listed electrical tape (by others).
-
Place the Fixture against mounting surface allowing the two machine screws to pass through the holes of the Fixture Housing. Fasten it with the Mounting nuts (provided).
-
Install the lamp(s) (by others) Do Not Exceed Recommended Wattage.
-
Install Fixture Trim with the four Mounting Screws (provided) as shown in figure below.
IMPORTANT: In order to comply with established electrical code, the installer must seal the area around the Fixture Base and the Wall, with type of caulking compound such as GE 100% or Dow Corning 100% silicone to provide a watertight seal in accordance with the differing surface textures of the wall.
NOTE:
To re-lamp, replacement parts or additional information,contact or visit
manufacturer at www.lumux.net
LUMUX – ARCHITECTURAL LIGHTING COMPANY- Toll Free 877-895-5552 www.Lumux.net
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>