EEZEE POWER Jeep JL Power Switch Panel Instruction Manual
- June 14, 2024
- EEZEE POWER
Table of Contents
EEZEE POWER Jeep JL Power Switch Panel Instruction Manual
General safety instructions
Please read this instruction manual carefully and familiarize yourself with
the instructions, the received components and the needed tools.
Eezee Power will not be responsible for any damage caused by the failure to
install the product according to these instructions.
All information in this guide has been prepared with great care. Eezee Power, however, does not accept liability for possible errors, changes and/or omissions. This user guide is for information purposes only and aims to support you in installing the Switch Panel completely by yourself. Individual applications may not be covered and need different handling.
If you do not understand the instructions and/or you do not feel confident enough to tackle the installation, you should have the product installed by a professional.
What you see is what you get
-
Fuse : 3 amp fuse of the switch panel. In case the switch panel does not turn on, it is recommended to check this fuse.
-
Switch 1 : low voltage cut off (on or off) Switch 2: panel startup function (ignition or battery)
See pages 10 and 11 for more information about these functions. -
Main power cable positive side : connect this cable directly to the positive pole of the 12V battery.
Attention: 24V batteries are not allowed! -
Ground cable of the switch panel : connect this cable directly to the negative pole of the 12V battery
-
Ignition cable : connect this cable to the ignition of your vehicle and the switch panel will power up when the car is turned on. See pages 10 and 11 for more information about these functions.
-
Switch panel cable that connects the relay box to the switch panel.
-
Connect the positive and negative side of your 12V accessories here (maximum 30 amp per output)
-
Fuse and relays (it is recommended to match the fuse to the type of cable you are using)
Attention: never fit a fuse larger than 30 amps!
Switch 2 – Switch Panel Start-up
You can link the switch panel to the vehicle’s ignition. In this case,
starting the car will automatically turn on the switch panel and turning off
the ignition will automatically switch off the panel.
You can also program the switch panel to be manually switched on and off by pressing the power button behind the Eezee Power logo.
- Photo 3: ignition start-up. The switch panel will be active when the ignition is on. You must connect cable 5 to the ignition of your car in order to use this function.
- Photo 4: manual start-up. The switch panel is always active and you turn it off and on with the power button in the middle of the switch panel. Cable 5 should not be connected to use this function.
Problem: The Switch Panel doesn’t light up.
Remedy: Check the fuse alarm light. If the alarm light lights up, you need to
replace the 3 amp fuse.
Problem: The Switch Panel blinks and doesn’t react to commands.
Remedy: The low voltage cut-off function will be activated when the battery
voltage is less than 11V. The Switch Panel will blink to show you that this is
the problem. When the battery voltage is higher than 12.SV, the Switch Panel
will function normally again.
Problem: The Switch Panel doesn’t light up when the ignition control wire is
connected. Remedy: Check the Add-a-Fuse tool. Make sure that it is connected
in the correct position and that the factory fuse is installed in the
Add-a-Fuse tool.
Problem: The Switch Panel doesn’t turn on, yet everything is intact.
Remedy: Test the pin control wire continuity.
Problem: I have an issue with the Switch Panel that is not listed above.
Remedy: please contact us at info@eezeepower.eu with a clear description of
the problem.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>