ORANIER GSV660 Fully Integrated Dishwasher Instruction Manual
- June 1, 2024
- ORANIER
Table of Contents
ORANIER GSV660 Fully Integrated Dishwasher
Load the Dishwasher
Basket Loads
Lower basket :
- Correct placement of dishes with plates upright and spaced apart.
- Incorrect placement depicted with a cross showing overcrowded and overlapping dishes.
Upper basket :
- Correct placement of glasses and bowls upside down to allow water to reach the interior surfaces.
- Incorrect placement depicted with a cross showing glasses and bowls not upside down, which may prevent proper cleaning.
Incorrect loads can lead to poor washing and drying performance. Please follow the manufacturer’s recommendations for good washing results.
Washing Programmes
Programme Table
Operation
Control panel overview with buttons and displays for operation:
- On/off button
- Programme selection button
- Display
- Button for start time delay
- Half load button
Displays:
- Half load display
- Warning display “Refill regenerating salt”
- “Top up rinse aid” warning display
Change Programme
To change a programme during operation, open the appliance door, press the
programme selection button to select a new programme. The new programme
continues from where the old one was interrupted.
Cancel Programme
To cancel a programme, open the door, press and hold the programme
selection button for 3 seconds until “1” appears in the display. Close the
door to start the pump, which runs for 30 seconds, followed by 5 buzzer
sounds.
Switch off the Machine
To switch off the machine after a programme is complete, press the on/off
button. If the machine will not be used for a long time, unplug it and turn
off the tap.
Set up Sumner
To change the buzzer sound level, open the door and press the programme
selection and start time delay buttons simultaneously for 3 seconds.
Energy Saving Mode
To activate or deactivate energy-saving mode, open the door and press the
start time delay and half charge buttons simultaneously for 3 seconds.
Floorlight (depending on model)
Floorlight | Device status |
---|---|
Green, permanently illuminated | The device executes a programme. |
Green, flashing | A programme was cancelled. |
Green, fast flashing | The device is faulty. See section “Automatic error |
warnings and remedial action”.
The LED goes out| A programme has ended.
Specifications
Programme| Description| Degree of Soiling| Duration| Electricity (kWh/cycle)|
Water (l/cycle)
---|---|---|---|---|---
P1| Standard programme for normally soiled crockery with reduced energy and
water consumption.| Medium| 03:25| 0.923| 12.0
P2| Suitable for heavily soiled tableware.| Strong| 01:57| 1.700| 17.2
FAQ
Q: How do I load the dishwasher correctly?
A: Place dishes in the lower basket with plates upright and spaced apart. Glasses and bowls should be upside down in the upper basket to allow water to reach all surfaces.
Q: What should I do if the dishwasher is not cleaning properly?
A: Ensure that dishes are not overcrowded and are placed as per the manufacturer’s recommendations. Check if the rinse aid or regenerating salt needs refilling.
Q: How can I change or cancel a programme?
A: To change a programme, open the door and press the programme selection button. To cancel, press and hold the same button for 3 seconds.
Q: What do the floorlight indicators mean?
A: A green, permanently illuminated light means the device is running a programme. Flashing green indicates a programme was cancelled. Fast flashing green suggests a fault, and the LED going out signifies the end of a programme.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>