GENYED TGN009 Safety Glasses Owner’s Manual

Table of Contents

GENYED-TGN009-Safety-Glasses-product

Specifications

Cleaning

Cleaning should only be done with a specific lens cloth.
The standard anti-fog treatment gradually fades and is likely to come off after washing. Therefore, only use lens-specific cloths.
Do not clean any part of the product with petrol, chlorinated degreasers, organic solvents, or abrasive cleaning agents.

Storage Instructions

Store the glasses in a protected, dry, cool, and well-ventilated place away from sunlight and chemical and abrasive substances.
Store between 5 to 40 degrees Celsius; humidity less than 90%.

Warranty

FAQ

Q: Can I use any cleaning cloth to clean the glasses?
A: No, cleaning should only be done with a specific lens cloth to avoid damaging the lenses.
Q: How should I store the glasses when not in use?
A: Store the glasses in a protected, dry, cool, and well-ventilated place away from sunlight and chemical and abrasive substances.
Q: What is the warranty period for the product?
A: The product warranty is 2 years; however, damage resulting from improper use is not covered under warranty.

GENYED® TGN009 safety glasses made of polycarbonate lenses and a polycarbonate and foam frame.
Frame with foam protection that can be removed according to preference and type of use.
The product meets the European CE standard EN 166:2001 and complies with PPE Regulation (EU) 2016/425, CE and UKCA marked.
Anti-scratch and anti-fog lenses.
Lens protection: UV400.
Suitable for protection against low-impact shocks typical of factories, laboratories, educational establishments, DIY activities, etc., which could damage the eyes or impair vision.

Read the user manual carefully before using the product.
Do not modify or alter the product under any circumstances.
Do not use this product to protect yourself against risks other than those specified in this document/instruction manual.
GENYED® TGN009 safety glasses must be replaced after two years of use.

$GENYED-TGN009-Safety-Glasses- $1$$

Check carefully before putting on your glasses that the lenses are perfectly clean and free from scratches.
Wear the glasses before exposing yourself to any hazardous conditions for which protection is required.
PPE is intended for personal protection and must not be interchanged between multiple users.
Ensure that the protective glasses are worn comfortably.
Wear the glasses for the entire duration of exposure to the risks.
The sponge protector can be fitted and removed from the frame by using the releases at the marked points in figure 1. To remove it, first release points A and then gently pull on points B. Carry out the operations in reverse for mounting.
If the glasses have scratches, damage or have been subjected to shocks, replace them immediately.

Cleaning should only be done with a specific lens cloth.
The standard anti-fog treatment gradually fades and is likely to come off after washing. Therefore, only use lens-specific cloths.
Do not clean any part of the product with petrol, chlorinated degreasers, organic solvents or abrasive cleaning agents.

Store the glasses in a protected, dry, cool and well-ventilated place away from sunlight and away from chemical and abrasive substances.
Store between 5 to 40℃; humidity less than 90%.