MAX FITNESS Lean Board Vario Instruction Manual
- June 1, 2024
- MAX FITNESS
Table of Contents
MAX FITNESS Lean Board Vario
Specifications:
- Product Name: LeanBoard Vario S
- Attachment method: Suction cups
- Surface requirements: Smooth and stable surfaces
- Storage recommendation: Remove from surface after use and store carefully
Product Usage Instructions
Attaching the LeanBoard:
- Ensure that the surface is smooth and stable.
- Press all four suction cups of the LeanBoard firmly onto the surface.
- Check that all four suction cups are securely attached.
Using the PickUp:
- Plug in the PickUp ensuring all four pins are inserted completely.
- Verify that the connection is secure before use.
Removing the LeanBoard:
- Gently lift the LeanBoard to detach the suction cups from the surface.
- Store the LeanBoard carefully in a suitable location to prevent damage.
Note:
Avoid leaving the LeanBoard attached to surfaces for extended periods,
especially if the surface is not smooth enough, to prevent potential damage.
FAQ:
-
Q: Can the LeanBoard Vario S be used on all types of surfaces?
A: The LeanBoard Vario S is designed for use on smooth and sufficiently stable surfaces to ensure proper attachment and safety during use. -
Q: How should I check if the LeanBoard is securely attached?
A: After attaching the LeanBoard using the suction cups, visually inspect all four suction cups to ensure they are pressed correctly onto the surface.
Introduction
- The LeanBoard Vario S is attached by pressing the four suction cups onto a clean and smooth surface, such as a door. After fastening, the PickUp can be plugged in by placing two of the four pins first.
- Then connect the other two pins. To remove the LeanBoard, there are release tabs attached to the suction cups, which are released in pairs, first on one side and then on the other side.
- Thanks to the variable attachment of the LeanBoard, the PickUp can be used for fascia massage at any height and orientation (vertical, horizontal, diagonal).
Important instructions
Attachment using the suction cups is only possible on smooth and sufficiently stable surfaces. Immediately after attaching the LeanBoards must be checked to see whether all four suction cups are pressed correctly. Immediately after plugging in the PickUp, check whether all four pins are plugged in completely.
After completing the exercise, it is recommended to remove the LeanBoard from the surface and store it carefully. Over longer periods and connected to surfaces that are not sufficiently smooth, the LeanBoard may loosen and possibly be damaged or cause damage by falling.
Attaching
Removing
Contact Information
- MAX FITNESS GmbH Marktplatz 6 88316 Isny im Allgäu Deutschland
- info@maxfitness.shop.