Open Throttle F80 M3 F82 M4 Yellow DRL Conversion Kit Instruction Manual
- June 1, 2024
- Open Throttle
Table of Contents
F80 M3 F82 M4 Yellow DRL Conversion Kit
Instruction Manual
Open throttle YELLOW DRL installation manual
Disclaimer
Please read the following carefully and only proceed once you have fully understood and agreed to the terms:
- The buyer takes complete responsibility for utilizing these products on their vehicles, whether or not they adhere to relevant laws and regulations governing on-road or highway usage.
- The buyer recognizes that OPEN THROTTLE specifies that the products are designed exclusively for off-road or racetrack use.
- The buyer agrees that OPEN THROTTLE is not responsible for ensuring compliance of their vehicles with State, Federal, Provincial, or local ordinances and emissions authorities.
- The buyer that all installations are done entirely at the risk of the buyer, and OPEN THROTTLE cannot be implicated in any way.
- OPEN THROTTLE disclaims any responsibility for damages resulting from misuse, abuse, improper installation, improper operation, lack of responsible care, or issues related to part incompatibility.
- OPEN THROTTLE will not honour warranties due to improper installation, improper maintenance, any damage caused by external factors and wear & tear.
REQUIRED TOOLS
– TORX T20
Included parts
– OPEN THROTTLE Yellow DRL Modules (2)
Prior information
– This guide assumes that your vehicle has an OEM LCI Headlights (2017-2020)
– This guide assumes that your vehicle has headlights in working order.
step 1
Open the bonnet by pulling the latch under the steering wheel twice.
step 2
Take out the (3) t20 screws from headlight MODULE/heatsink. (refer to picture
below)
DO NOT LOSE THESE ARE THEY ARE REQUIRED TO REINSTALL NEW HEATSINK/MODULE 
Step 3
Carefully lift the MODULE/heatsink and unplug (2) connectors (push down on tab
and pull) 
Step 4
Takeout OLD MODULE/heatsink – put aside. 
Step 5
Plug the (2) cables back into the new heatsink. 
Step 6
CAREFULLY PLACE NEW MODULE/heatsink INTO HEADLIGHT CASING 
Step 7
TURN ON IGNITION WITH HEADLIGHT SWITCH SET TO – (0)
CHECK IF DRL IS WORKING PROPERLY BEFORE PROCEEDING TO NEXT STEP. IF NOT
WORKING PROPERLY – PLEASE DOUBLE CHECK IF THE PLUGS ARE CORRECTLY SEATED.
Step 8
SCREW IN (3) T20 SCREWS
DO NOT OVERTIGHTEN 
Step 9
REPEAT STEPS 1-8 FOR OTHER HEADLIGHT. 
ISSUES WITH INSTALLATION?
Please email us at:
support@openthrottle.shop
Youtube video:
www.youtube.com/watch?v=OiibFvs2wZo
Open throttle. shop
Documents / Resources
| Open
Throttle F80 M3 F82 M4 Yellow DRL Conversion
Kit
[pdf] Instruction Manual
F80 M3 F82 M4 Yellow DRL Conversion Kit, F80 M3 F82 M4, Yellow DRL Conversion
Kit, DRL Conversion Kit, Conversion Kit, Kit
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>