LiteBee Y18 Obstacle Avoiding Unit User Manual
- June 4, 2024
- LiteBee
Table of Contents
Obstacle Avoiding Unit
Product Manual
Introduction
The obstacle avoiding module is one of extensions for LiteBee Wing drone, it can sense the obstacle of 5 directions(forward/backward/left/right/below). Combined with LiteBeeGo programming, the module enables the drone to avoid the obstacle and the following crash.
This module makes the knowledge application more interesting, allowing students to learn through play, and inspire their curiosity for exploring drones and AI.
Packing list
Obstacle avoiding unit 1 Connecting cable 1
Short bolt * 1
Specification
Model: Y17-AI
Size: 40408mm
Working voltage/current: 5V/@80mA
Size of QR code: 24*30cm
Max load: 500g
Actual load: 0-8g
PREPARATION
Firmware version
Note:
To apply this module, the version of firmware for aircrafts or controllers should be V1.1.0 (and up), the version of software should be LiteBee Go V0.2.1(and up).
How to check the version
Link the aircraft with the controller
↓
Connect the controller with the host computer by USB micro wire
↓
Switch the controller into programming mode
↓
Start LiteBee Go
↓
Click the “Add Extension”
↓
Choose “LiteBee Wing” mode
↓
Click the exclamation mark to make sure the controller connected
↓
Check the information on the right bottom
FV shows the version of the aircraft
RV shows the version of the controller
pic 1
pic 2
pic 3
pic 4
How to update the firmware version
To download the corresponding document for firmware upgrading on LiteBee official web Or, you can find relevant video for firmware upgrading on YouTube channel – LiteBee, search “Guide for firmware upgrade” Official Website:https://www.litebee.com/product/liteBeeWing/download
DOWNLOAD
pic 5
INSTALLATION
-
Insert four short bolt into the bottom of the drone
-
Insert the connecting cable into the obstacle avoiding module
-
Install the module in the bottom of the drone by short bolt
-
Pay attention to side of the module
- Link the connecting cable to drone’s 4-pin interface
EXTENSION PROGRAMMING
Step 1: Connect the aircraft with the host computer
Turn the drone on and link to the controller
↓
Connect the controller with the host computer by connecting cable
Step 2: Switch to obstacle avoiding mode
Start LiteBee Go
↓
Click “Add extension”
↓
Choose “Obstacle abvoiding mode”
PS: Click the excalmatory mark if the it isn’t connected.
Reference case
Mission:
Let the drone take off and then fly forward, landing if meet any obstacle.
Programming case
Mind map
Start
↓
Calibrate
↓
Take off and fly forward
↓
If the distance between aircraft and obstacle less than 30 cm
↓
Land
Manufacturer: Shenzhen Makerfire Technology Co., Ltd.
Website: www.litebee.com
Tel: 44-830-2598
Email: sales@litebee.com
Address: 25th Floor, A7 Building, Creative City, Liuxian Ave, Xili Street,
Nanshan
District, Shenzhen, China.
References
- LiteBee Kids Drones | Professional Programming Drone for Kids| Coding for Kids
- Educational drone Coding for Beginners | Support-litebee wing
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>