LiteBee Y-17 Wing Electromagnet Module User Manual

LiteBee Y-17 Wing Electromagnet Module

Product introduction

The electromagnet extension is an additional accessory for LiteBee Wing. It can lift and drop the iron materials by its electromagnet. Combined with the drone, the extension also can be programmed to transfer the matrials automatically. This extension provides a chance for kids to practice their programming skill and learn how the programming can be applied.

ABOUT THE PRODUCT

Packing list

Specification

PREPARATION

Firmware version

Description
To apply the electromagnet, the firmware version of drone and controller should be V1.1.0 and up, the version of PC software – LiteBee Go should be V0.2.1 and up.

How to check the version

FV shows the version of the aircraft
RV shows the version of the controller

How to update the version

To download the corresponding document for firmware upgrading on LiteBee official web Or, you can find relevant video for firmware upgrading on YouTube channel – LiteBee, search “Guide for firmware upgrade” Official Website:https://www.litebee.com/product/liteBeeWing/download

DOWNLOAD

INSTALLATION

• Disassemble these arms of rotor；

• Remove these short bolts.
  

• Replace them by long bolt；

• And then reassemble it.
  

• Fix the electromagnet on the holder with a screw；

• Tighten the screw until it can’t twist.
  

• Fix the counterwight holder on the front；

• Fix the electromagnet on the back.
  

• Insert 4 short bolts into the bottom of the drone.
  

• Insert the connecting cable into the electromagnet unit.
  

• Install theelectromagnet unit on the bottom of the drone；

• Attention: the blank side face to the bottom of the drone.
  

• Insert the cable into the broadside of the drone.
  

• Connect the power line with the electromagnet unit.
  

Finished

EXTENSION PROGRAMMING

Step 1: Connect the drone with computer

Step 2: Electromagnet mode

PS: If there is a green tick mark, connected; if a orange exclamation, click the exclamation to connect again.

Reference case

Task
Let the drone fly to the QR code No.0 and hover; then land and turn on the electromagnet and lift the adsorbate; take off again and fly to the QR code No.10; hover and turn off the electromagnet to drop the adsorbate; land.
Case
Mind map

Manufacturer: Shenzhen Makerfire Technology Co., Ltd.
Website: www.litebee.com
Tel: 44-830-2598
Email: sales@litebee.com
Address: 25th Floor, A7 Building, Creative City, Liuxian Ave, Xili Street, Nanshan
District, Shenzhen, China.

References

• LiteBee Kids Drones | Professional Programming Drone for Kids| Coding for Kids
• Educational drone Coding for Beginners | Support-litebee wing

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>