GROW K202 Control Board User Manual
- June 3, 2024
- GROW
Table of Contents
K202 Control Board
User Manual
K202 Control Board
| P1:Power Supply | K1:SET Button |
|---|---|
| P2:Fingerprint Module(1.25mm Interface) | K2:Relay Time Button |
| P3: Fingerprint Module(1.00mm Interface) | P4:Relay Output |
Technical parameter：
P1: Power supply: DC12V
Output: Relay(Max. current:10A)
Standby current: 15uA
Fingerprint capacity: 120 pieces
Size: 64.4*25.4mm
P2: MX 1.0mm space 6 Pin Fingerprint Module
P3: MX 1.25mm space 6 Pin Fingerprint Module
Instructions for control board：
-
SET Button: Press the SET button shortly, the blue indicator light flashes fast and the system is in the register state, put your finger on the fingerprint collection area, the fingerprint register is successful when hearing music. Fingerprints can be registered continuously when the system is in a registered state; if no need to add a fingerprint, wait a few seconds.
-
Back to factory default: Press the SET button until hearing a “Di” long beep and music,means the initialization operation is successful.
-
Set Relay Time: Rotate K2 to set the closing time of the relay from 0.5 to 13 seconds.
The relay is contact output, switch signal, no voltage output. -
Usage: Press the finger,the relay closes after the fingerprint passes, and the closing time is determined by K2.
Note:
- All indicator lights are off in standby state, and the lights are on in working state;
- Any fingerprint can be used in the factory state, but the function will be invalid after the fingerprint is registered.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>