SRP COMPANIES True Wireless Earbud With Charging Case User Guide
- June 14, 2024
- Srp Companies
Table of Contents
TRANSLUCENT TWS EARBUDS
True wireless earbuds
with charging case
FCC ID: 2ATF5-68553
ADDITIONAL
Congratulations on your translucent TWS earbuds, These BT earbuds allow you to
enjoy your music without wires.
Please read this manual before use,
NOTICE:
- Keep the product dry; do not place the product in damp places
- Keep cut of direct sunlight and high temperatures High temperatures May result in damage
- Keep cut of cold temperatures. this will help to avoid internal damage
- Do not disassemble the product
- Avoid dropping the headphones
- Do not continue to charge the headphones over 10 hours
- When charging use the Micro USB charging card that came with the headphones
PACKING LIST
- Charging case
- Multifunctional button
- Indicator
- Battery indicator
SPECIFICATIONS
| Frequency range (Hz-KHz) | 20Hz— 20 KHz |
|---|---|
| Continuous playing time | 2.5-3 hours |
| Charging time | 1.5 hours |
| Battery capacity Earbuds : | 30 mAh |
| Battery capacity Charging station | 300 mAh |
| Mic function : | yes |
| Pick up function : | yes |
| BT version : | 5.0 |
USING INSTRUTION
- Take out the earbuds from the charging case, they will be power on and pair automatically after the indicator flashing in red /blue color for 1-2 seconds.
- Activate your pairing device’s BT mode.
- Search for “SR-42283” and select it to connect.
- After the connection is successful, the earbud’s light will be off.
Precaution
- Earbuds will automatically be power off if there is no operation in 5 minutes after switch on. When the phone is out of distance, earbuds is disconnected. When return to the communication distance, the earbuds will automatically connect to the phone.
VOICE INSTRUCTION
“Ding” – Power on
“Ready to be connected” -Device ready
“Connected”- Successfully connected
“Incoming call”- Phone call
“Low Battery”-Battery needs to be charged
“Ding-Ding”-Disconnected
FUNCTION KEYS
INDICATOR LIGHT STATUS
| Paring Mode | Led light flash in red/blue color |
|---|---|
| Working | The light is off |
| Low Battery | LED light flash red slowly |
| Charging | Earbuds: red light is on; Case: LED light flash orange |
| Full charge | Earbuds: red light is off; Case: Orange light is on |
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
FCC ID: 2ATF5-68553
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>