GROW ELITE 554221110 GL30W Suspendable LED Plant Grow Light User Guide

GROW ELITE 554221110 GL30W Suspendable LED Plant Light User Guide

Part # GEGL-30WHU-FS
Model # 554221110

THANK YOU
We appreciate the trust and confidence you have placed in Grow Elite through the purchase of this LED product. Visit us online to see our full line of products. Thank you for choosing ETi!

Safety Information

WARNING: Carefully read and understand the information given in this manual before beginning the assembly and installation. Failure to do so so could lead to electric shock, fire, or other injuries which could be hazardous or even fatal.

WARNING: Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the circuit breaker.

WARNING: This product must be installed in accordance with the applicable installation codes by a person familiar with the construction and operation of the product and the hazards involved.

CAUTION: Ensure the fuse or circuit breaker provides sufficient amperage for the 105°C rated power cord.

WARNING:

• Should not be concealed or extended through a wall, floor, ceiling, or other parts of the building structure.
• Should not be permanently affixed to the building structure.
• Should not be subject to strain or possible physical damage.

NOTICE: The voltage and current rating of portable luminaire is AC 120V, 60Hz, 0.28A, 30W.

NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

WARNING: Risk of electrical shock. To reduce the possibility of serious injury, always take the proper precautions and unplug the fixture before moving or cleaning.

WARNING:

• Not allow to remove the connector before disconnect the electrical.

WARNING: The minimum required distances (200 mm) between adjacent lighting equipment and between the lighting equipment and combustible materials such as walls, ceilings, movable partitions, and the like; and between lighting equipment and other heat generating equipment.

Warranty

This product is warranted for a period of 3 years from the date of original purchase against defects in materials and workmanship. No ETi-SSL or reseller, agent, or employee is authorized to make any modification, extension, or addition to this Warranty. If any term is held to be illegal or unenforceable, the legality or enforceability of the remaining terms shall not be affected or impaired. This Warranty is governed by and construed under the laws of the country in which the Product purchase took place. If this product should fail to operate due to defects in material or workmanship within 36 months of purchase, see www.ETiSSL.com for details. This product will be repaired or replaced, at ETi’s option. This warranty is expressly limited to repair or replacement of product and liability for direct, incidental, or consequential damages is hereby expressly excluded. Some states / provinces do not allow exclusions of direct, incidental or consequential damages, so the above limitation of exclusion may not apply to you. This warranty gives the consumer specific legal rights, which vary from state to state / province to province. FOR A FULL UNDERSTANDING OF YOUR RIGHTS YOU SHOULD CONSULT THE LAWS OF YOUR STATE / PROVINCE. Residents of Quebec are governed by that province’s consumer protection legislation. WARRANTY IS VOID IF PRODUCT IS NOT USED FOR THE PURPOSE WHICH THIS PRODUCT IS MANUFACTURED.

Important Safety Instructions

This portable luminaire has a polarized plug (one blade is wider than the other) as a feature to reduce the risk of electric shock. This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Never use with an extension cord unless plug can be fully inserted. Do not alter the plug.

Pre-Installation

PLANNING INSTALLATION

Before beginning assembly, installation or operation of the product, make sure all parts are present. Compare the parts with the list of package contents. If a part is missing or damaged, do not attempt to assemble, install or to use the product. Contact customer service for replacement parts.

NOTE: Keep your receipt and these instructions as proof of purchase.

If you are unfamiliar with electrical installations, we recommend that you contact a qualified electrician to perform the installation.

TOOLS/HARDWARE REQUIRED

PACKAGE CONTENTS

Installation

Select a suitable location that can support the weight of the LED Plant light. The light must be mounted a minimum of 8 inches from adjacent lighting equipment and from materials including, but not limited to, walls, ceilings, movable partitions, and other combustible materials.

NOTE: When determining the desired location for suspension mounting the light fixture, make sure the light fixture is located directly below the electrical outlet and that the distance between the electrical outlet and the end of the light fixture is less than 10 ft.

Mounting to Ceiling

Mark two spots on the ceiling 19.68 in. (500mm) apart for suspension mounting before the installation.

1. Mounting to wood

   • Drill two 1/16 in. diameter holes in the ceiling.
   • Tighten the hook screw (B) into the wood.

2. Mounting to drywall

   • Drill a 1/8-in. pilot hole into each of the screw locations marked on the ceiling. You can also use an awl or nail to dimple the screw holes.
   • Install a drywall anchor (not included) and a hook screw (B) in each drilled mounting hole.

3. Attaching the V hooks (C)

   • Pierce the V hook (C) through one end of the mounting chain (D).
   • Then attach to the hook screw (B) on the ceiling.

4. Attaching the plant light (A)

   • Slide the V hook (C) through the mounting holes on the plant light (A).

   • Plug the power cord (E) into the end of the plant light (A) and then plug the other end of the power cord (E) into an electrical outlet.
     CAUTION: Attach the power cord to the chains (D) with cable ties (not included). Secure the power cord to the ceiling using cord clips (not included), if applicable.

   • Use the power switch to activate the fixture.

Mounting to Mount Bar

1. Attaching the V hooks (C)

   • Pierce the V hook (C) through one end of the mounting chain (D).
   • Then cross the chain (D) over the pole and fasten it with the hook.
     

2. Attaching the plant light (A)

   • Slide the V hook (C) through the mounting holes on the plant light (A).

   • Plug the power cord (E) into the end of the plant light (A) and then plug the other end of the power cord (E) into an electrical outlet.
     CAUTION: Attach the power cord to the chains (D) with cable ties (not included). Secure the power cord to the ceiling using cord clips (not included), if applicable.

   • Use the power switch to activate the fixture.
     

Linking Multiple Plant lights

Multiple light fixtures can be connected, up to a maximum of ten plant lights or 300 total watts. Only the first light fixture needs to be plugged into an electrical outlet.

• Connect each additional fixture using either the linking cable (F). The maximum distance between two light fixtures is 3 ft.
• Remove the end cap from the plant light before connecting the product.
• For best results, fully insert the linking cable (F) into the receptacle in the end of the plant light.

WARNING: RISK OF ELECTRIC SHOCK. Disconnect power to the plant light before linking additional plant lights. If the receptacle on the end of the plant light is not used to link to another fixture, the receptacle needs to be closed by the end cap. Do not touch live parts inside the receptacle.

Planting Suggestion

One-unit Planting:

• Recommended that the green plants and lamps should be placed on the 15-20cm under the luminescent surface of and placed near the window where part of the sunlight can be accepted.

• The recommended planting distance in winter is 15cm (5.9in.),

• The average value of PPFD is 205µmol/s/m² , Effective planting area 45×25 cm² (17.7×9.8 in.²).

• The recommended planting distance in summer is 20cm (7.9in.),

• The average value of PPFD is 197µmol/s/m² , Effective planting area 45×25 cm² (17.7×9.8 in.²).

Two or multi units Planting:

• It is suggested to install multi lights in a line arrangement to obtain better planting effect and larger planting area.

• The recommended planting distance in winter is 15cm (5.9in.), The average value of PPFD is 205 µmol/s/m² , Effective planting area 108×25 cm² (42.5×9.8 in.²).
• The recommended planting distance in summer is 20cm (7.9in.),
• The average value of PPFD is 197 µmol/s/m² , Effective planting area 108×25 cm² (42.5×9.8 in.²).

Care and Cleaning

CAUTION: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the fuse from the fuse box.

• Clean the fixture with a soft, dry cloth.
• Do not use cleaners with chemicals, solvents, or harsh abrasives.
• Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light fixture.

Troubleshooting

WARNING: Before doing any work on the fixture, disconnect power to the light fixture.

Minor problems often can be fixed without the help of an electrician.

Questions, problems, missing parts?
Call Grow Elite Customer Service
8 a.m. – 5 p.m., ET, Monday – Friday

1800-916-7680

www.GrowEliteLED.com

Retain this manual for future use.

References

• ETi Solid State Home - ETI SSL
• ETi Solid State Home - ETI SSL
• Professional LED grow lights | Samsung LED Lights for expert growers

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>