DuraTherm 1720mm Radiator Cover Instruction Manual
- June 1, 2024
- DuraTherm
Table of Contents
DuraTherm 1720mm Radiator Cover
Instruction Manual
An illustration shows the final assembled product, a two-door cabinet with a lattice pattern on the doors. A note indicates “Please note that there is no No.2 panel!” Tools needed for assembly are listed as a churn drill, hammer, and cross screwdriver.
PARTS
Specifications
| Part | Quantity | Dimensions |
|---|---|---|
| Panel 1 | x1 | 803±10*12mm |
| Panel 3 | x1 | 803±10*12mm |
| Panel 4 | x4 | 681±10*12mm |
| Panel 5 | x2 | 7204793mm |
| Panel 6 | x1 | 80316812mm |
| Panel 7 | x1 | 86019012mm |
| Screws A | x3 | N/A |
| Screws B | x20 | N/A |
| Screws C | x22 | N/A |
| Screws D | x18 | N/A |
| Screws E | x16 | N/A |
| Screws F | x6 | N/A |
| Screws G | x6 | N/A |
| Screws H | x2 | N/A |
| Screws I | x8 | N/A |
| Screws J | x1 | N/A |
TOOLS
Assembly Instructions
Using a screwdriver, screw in the #B screws securely. Please do not over tighten as it may cause wood to split. The small arrow on the #C Cam Lock Screw should be facing the #B screws extending from the panel. Use screwdriver to tighten securely, but avoid over-tightening, screws may protrude through the panel.
- Attach side panels (labeled B) to the bottom panel (labeled C) using screws D and H. Place cam locks F in the side panels.
- Attach the top panel (labeled A) to the side panels using screws D and cam locks F.
- Attach the back panels (labeled E) to the assembled frame using screws G.
- Install the doors (labeled I) to the cabinet using screws J.
- Warning: Keep the panels 9 & 10 on the same level when moving or the screws may protrude through the panels.
- Final step shows the fully assembled cabinet with all panels and doors in place.
FAQ
What should I do if a screw protrudes through the panel?
Ensure that you have not over-tightened the screws and that all panels are kept on the same level during assembly and movement to prevent this issue.
How do I ensure the Cam Lock Screws are properly aligned?
When inserting the Cam Lock Screws #C, the small arrow on the screw head should face the direction of the corresponding #B screw that will be inserted into the lock.
What is the function of the Cam Lock Screws?
Cam Lock Screws #C are used to securely fasten the panels together without the need for additional tools or hardware.
Can I use a power drill instead of a screwdriver?
While a power drill can be used, it is important to be cautious and not over- tighten the screws, which can cause damage to the wood.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>