Duratherm 1MVH Flat Panel Heated Towel Rail Installation Guide
- June 14, 2024
- DuraTherm
Table of Contents
Duratherm 1MVH Flat Panel Heated Towel Rail Installation Guide
Tools Required
Package Content
| Blanking Plug| x1
---|---|---
| Air Vent| x1
| Washer| x4
| Long Screw| x4
| Masonry Wall Plug| x4
| Spacer| x4
| Wall Support| x4
| M5X12 Cross Screw| x4
| M6X25 Cross Screw| x4
Installation Instructions
Apply PTFE tape(not supplied) to the blanking plug and insert them into the top left threaded holes. Apply PTFE tape(not supplied) to air vent plug and insert them into the top right threaded holes.
After installation…
- Use a screwdriver to open the air vent, open the valve and let the water rush into the towel warmer. Check all connections for leaks.
- Once water overflows from the air vent, there is no air in the tube.
- Use a screwdriver to close the air vent, turn on the valve and the towel warmer is ready for use.
After care…
- Classic towel warmers are made from steel with chrome plating, and should not be cleaned with corrosive or scouring cleaning agents.
Please note…
- This product can only be used at PN 1MPa (10g/cm², 10Bar), It should only be filled with water, and at a temperature below 100°C (212°F). See table below for installation requirements.
If the temperature exceeds 48°C (or 120°F), please install a warning sign near the product to avoid
burning and scolding accidents.
Fill 3/4 Full
water only
Pressure
PN 1 Mpa
Temperature
0″ C <t≤ 100°C
Comments
If ambient temperature drops below1°C. drain out the water to prevent
freezing.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>