ARTIKA FOR LIVING FAN-SUR2 Multi Single Cct Remote Fan Instruction Manual
- June 1, 2024
- Artika For Living
Table of Contents
ARTIKA FOR LIVING FAN-SUR2 Multi Single Cct Remote Fan
BATTERY WARNING
INGESTION HAZARD: This
product contains a button cell or coin battery
DEATH or serious injury can occur if ingested.
A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
KEEP new and used batteries OUT OF REACH of CHILDREN
Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.
- WARNING – KEEP BATTERIES OUT OF REACH OF CHILDREN
- Swallowing may lead to serious injury in as little as 2 hours or death, due to chemical burns and potential perforation of the esophagus.
- If you suspect your child has swallowed or inserted a button battery, immediately seek urgent medical assistance.
- Examine devices and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened. Do not use if compartment is not secure.
- Dispose of used button batteries immediately and safely. Flat batteries can still be dangerous.
- Tell others about the risk associated with button batteries and how to keep their children safe.
REMOTE CONTROL
NOTE – READ AND KEEP THESE INSTRUCTIONS
NOTE:
-
This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the battery, and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. -
All batteries must be properly disposed of and kept out of reach of children.
-
Even used batteries may cause injury.
REPLACING THE REMOTE CONTROL BATTERIES
- Always purchase the correct size and grade of battery that is suitable for the intended use.
- Replace all batteries within a set at the same time. Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.
- Clean the battery contacts and the contacts on the device.
- Ensure the batteries are installed correctly with regard to polarity (+ and -).
- Remove batteries from any equipment that will not be used for a long time.
- Remove used batteries promptly.
- Batteries must be installed, removed and replaced by an adult or under adult supervision.
- Dispose of batteries in accordance with local regulations.
- Do not attempt to burn batteries or place them near a heat source.
REMOTE CONTROL FUNCTIONS
REMOTE CONTROL PAIRING INSTRUCTIONS
REM-ART-1
Fan single CCT remote
-
Turn the fixture power off for at least 15 seconds.
-
Turn the fan on.
Press the FAN ON/OFF button (no. 4) and the LIGHT ON/OFF button (no. 7) simultaneously within 10 seconds of turning on the fan. You will hear 2 ‘’beep’’ sounds when the pairing is complete. -
If pairing is not successful, repeat the steps above.
REM-ARTC-2
Fan multi CCT remote
REMOTE CONTROL PAIRING INSTRUCTIONS
-
Turn the fixture power off for at least 15 seconds.
-
Turn the fan on.
Press the LIGHT ON/OFF button (no. 4) and the WARM button (no. 8) simultaneously within 10 seconds of turning on the fan. You will hear 2 ‘’beep’’ sounds when the pairing is complete. -
If pairing is not successful, repeat the steps above.
WARNING
BATTERY WARNING
( a ) KEEP OUT OF REACH OF CHILDREN
( b ) If the battery compartment (if applicable) cannot be easily removed,
stop using the product and keep it away from children.
( c ) If you think batteries might have been swallowed or placed inside
any part of the body, seek immediate medical attention.
MEMORY FUNCTION
The following parameters are memorized upon the user selection and whenever
the fixture is turned OFF by the remote or wall stich, the memory is stored
(DIMMING,FAN SPEED,POWER ON/OFF,ROTATION DIRECTION).
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>