Artika For Living OUT-HA LED Wall Light Instructions
- June 4, 2024
- Artika For Living
Table of Contents
Artika For Living OUT-HA LED Wall Light
LED WallLight Assembly And Instructions
Please read these instructions carefully before installing this product.
Suggest you keep these instructions in a safe places for future reference.
The light source contained in this luminaire shall only be replaced by the
manufacturer or his service agent or a similar quali-ed person.
All inside wires of this luminaire cannot be replaced; if the wires are
damaged, the luminaire shall be destroyed.
IF IN DOUBT, CONSULT A QUALIFIED ELECTRICIAN
Specification
| Watt | Lumen | Leds | Voltage | Frequency | CCT | **** |
|---|---|---|---|---|---|---|
| 10W | ≥650 | 60 | AC 120V | 60Hz | 3000K | 1.5 |
Dimension
Installation
Step 1. Turn off the power switch before installing.
Step 2. Use 2-8# -32 screws lock the mounting bracket to the junction box
or make 2-Φ8 holes in the wall, drive in the plastic tube expanding and use
2-ST6.2 screws lock the mounting bracket to the wall.
Step
3. Hang the hook on the mounting bracket and use the terminals connect the
wires as show as drawing. 
Step 4. Use 4 M4L10MM screws thread the wall
base to the mounting bracket, and check that the rubber washers is installed
correctly to ensure that the installation is waterproof. 
Step 4. Use 4 M4L10MM
screws thread the wall base to the mounting bracket, and check that the rubber
washers is installed correctly to ensure that the installation is waterproof.
Step
6. Fasten the No. plate into the wall base. 
Step 7. Put waterproof glue around the
base to make sure it’s waterproof. 
Step 8. Turn on power switch after installation completed.
FCC WARNING:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.