TOY FACTORY 2019-54 Remote Control Analysis Instruction Manual
- June 1, 2024
- TOY FACTORY
Table of Contents
TOY FACTORY 2019-54 Remote Control Analysis
HANDLE REMOTE CONTROL
USE 2X1.5V “AA” NON RECHARGEABLE BATTERIES ( NOT INCLUDED )
USES 1 X 3.7V RECHARGEABLE BATTERY (INCLUDED)
PRESS AND HOLD THE SWITCH FOR TWO SECONDS TO TURN IT ON. THE INDICATOR
LIGHT WILL FLASH AFTER SUCCESSFUL STARTUP.
WATCH REMOTE CONTROL
USE 2 X 1.SV “AAA” NON- RECHARGEABLE BATTERIES (NOT INCLUDED)
GESTURE FUNCTION: 1. SWING HAND BACK AND FORTH = CAR FORWARD/BACKWARD.
2. FINGER BUTTON + LEFT AND RIGHT SWING = CAR ROTATES LEFT AND RIGHT.
CODE MATCHING FUNCTION: WHEN THE CODE MATCHING IS UNSUCCESSFUL, THE HOST
LIGHT FLASHES; WHEN THE CODE MATCHING IS SUCCESSFUL, THE HOST LIGHT STAYS ON.
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>