Shantou Youbang Toy Factory 0088MT1261 2.4 G Remote Control Car Instructions
- June 6, 2024
- Shantou Youbang Toy Factory
Table of Contents
Shantou Youbang Toy Factory 0088MT1261 2.4 G Remote Control Car
Instructions
INSTRUCTIONS FOR USE
Use a Phillips screwdriver to loosen the battery cover at the bottom of the
car, install 3 1.5V “AN’ batteries on the bottom of the car, and lock the
battery cover tightly.
Loosen the remote control battery cover with a Phillips screwdriver, install 2
1.5V batteries in the remote control, and tighten the battery cover.
Turn the switch on the bottom of the car to “ON”, press and hold the remote
control “ON” for 3 seconds to start the car, and you can start playing.
When the indicator light of the remote control is dimmed, it means that the
battery is low and needs to be replaced with a new one.
When the battery of the remote control car is low, the speed of the remote
control car will slow down and it is not easy to walk upright. Please replace
the battery.
FEATURES INTRODUCTION
WARNING
CHOKING HAZARD – small parts, Not for children under 3 years.
WARNING:
Batteries are to be inserted with the correct polarity Do not mix different
types of batteries or new and used batteries. Non-rechargeable batteries are
not to be recharged. Rechargeable batteries are only to be charged under adult
supervision. Rechargeable batteries are to be removed from the toy before
being charged. The supply terminals are not to be short-circuited. Remove
batteries irom the toy when not in use for extended time or when batteries
become exhausted. Battery installation by an adult required Dispose of
batteries responsibly. Do not dispose of in fire.
Please keep the packaging for future reference Product may vary slightly from
image shown Read the instructions before operating this product Performance
Tips: Do not drive the vehicle on grass, sand, rocks or through water. Do
not drive the vehicle into any hard object.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>