WIWIURKA 4-In-1 Smart Wooden Furniture Instruction Manual

Table of Contents

4-In-1 Smart Wooden Furniture
Instruction Manual WIWIURKA 4 In 1 Smart Wooden Furniture - Figure
1

| |
---|---|---
Thank you for purchasing a
Wiwiurka handmade toy!| Assembly time
30-40 mins| Difficulty level
Basic

Please make sure you have the following pieces:

You will need an electric or manual screwdriver.

IMPORTANT

Remove all wrapping material before you start to assemble.
Sorting your pieces will make assembly easier.
Do not tighten all screws until completely assembled and make sure to screw the pieces at a low speed to avoid them from cracking.
The color sequence will vary depending on each color palette.

Start with one sideboard. Partially insert only one screw per slat, leaving the tip protruding out on the other side of the board. Please note that the Wiwi urka seal is stamped on the exterior face of the sideboard.
You may place the sideboard on top of a table or bench to make screw- driving more easier.
Align the first slat at one end of the sideboard, aligning the pre-drilled hole with the tip of the screw you previously inserted halfway. Fasten the screw without tightening in full and use a toothpick or alike tool as a guiding aide to align the slat with the second hole. Do not insert the second screw until the slat is properly aligned, otherwise, the screw may pierce through the wood damaging the piece.
Repeat the same process for the rest of the slats and the rod, which should be fully inserted in the pre-drilled slots before screwing it into the sideboard.
Flip the sideboard to place the second one on top and start screwing in all the slats and the rod without tightening them in full, always using your guid ing tool to align the predrilled holes and avoid wood damage.
Flip the Wiwiurka 4in1 Rocker upside down, in its climbing arch position, and apply downward pressure in order to ground it. You may hear some tiny cracks which are normal when the pieces are sitting into place. Once you have verified that the rocker is properly aligned and grounded, tighten all the screws.