iBoard IB-010C Running Boards Installation Guide
- June 1, 2024
- iBoard
Table of Contents
iBoard IB-010C Running Boards Installation Guide
PART LIST
Mounting Bracket List
Hardware Package A (For Bracket Installation)
Hardware Package B (For Stainless Steel Step Bar Installation)
STEP 1
Starting on the driver side front of the vehicle. Locate the (2) mounting
locations along the bottom of the body, (pinch weld), (Figs 1-2). Each
mounting location on the inner body panel is comprised of a rectangular hole
with a round hole on each side directly above each pair of holes in the pinch
weld.
STEP 2
Select (1) M10 Clip Nut. Insert the Clip Nut into the rectangular opening.
Line up the threaded hole on the Clip Nut with the round hole beside the
rectangular opening, (Fig 3).
NOTE: Make sure the threaded nut on Clip Nut must toward the inner side of the
rocker panel, (Fig 3).
STEP 3
Partially attach the Driver Front Mounting Bracket to the M10 Clip Nut with
the included (1) M10X1.5-30mm Hex Bolt, (1) M10 Lock Washer and (1) M10 Flat
Washer, (Fig 4).
Bolt the (1) lower hole on the Mounting Bracket to the (1) hole in the pinch
weld with the included (1) M10X1.5-30mm Hex Bolt, (2) M10 Flat Washers, (1)
M10 Lock Washer and (1) M10X1.5 Hex Nut, (Fig 4). Do not fully tighten
hardware at this time.
STEP 4
Move along the vehicle to the driver side rear mounting location. Repeat Steps
1-3 to install the Driver Rear Mounting Bracket.
Note: All (4) Mounting Brackets Are Universal.
STEP 5
Once all (2) Driver side mounting brackets are installed, then proceed to
the Step Bar installation. (Figs 5 & 6)
(1) Select (1) Slider and (2) M8X1.25-35mm Carriage Bolts;
(2) Install (2) M8X1.25-35mm Carriage Bolts in (1) Slider.
(3) Slide the Slider (with carriage bolts) to the Step Bar.
(4) Repeat to install the other (1) slider to the step bar.
(5) Attach the Step Bar (with the Sliders) onto the installed mounting
brackets. Position the Sliders to the installed brackets. Secure the Step Bar
to the installed Brackets by using (4) M8 Large Flat Washers and (4) M8 Nylon
Lock Nuts and (2) Sliders, (Fig 6). Do not fully tighten hardware at this
time.
Note: The Sliders are packed with the Step Bars.
Level and adjust the Step Bar and fully tighten all hardware.
Repeat Steps 1-5 for the other side Step Bar installation. The installation
is completed!!!
Attention
Do periodic inspections to the installation to make sure that all hardware is
secure and tight.
In order to protect your bars/boards, please use mild soap/non-abrasive
products for cleaning only.
Customer Support: info@iboardauto.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>