iBoard IB-P973C&J 6 inch Stainless Steel Running Boards Instruction Manual

iBoard® by APS
PART#: IB-P973C &J

IB-P973C&J 6 inch Stainless Steel Running Boards

READ INSTRUCTIONS CAREFULLY BEFORE START INGINSTALLATION. REMOVE CONTENTS FROM BOX AND VERIFY ALL PARTS ARE PRESENT. ASSISTANCE IS RECOMMENDED.

ROCKER PANEL MOUNT
NO DRILLING REQUIRED

Hardware Package A (For Bracket Installation)

Item| QTY| Description| Item| QTY| Description
1#| 12| M8X1.25-30mm Hex Bolts| 3#| 12| M8 Lock Washers
2#| 12| M8 Large Flat Washers| | |

Hardware Package B (For Step Bar Installation)

Item| QTY| Description| Item| QTY| Description
1#| 12| M8X1.25-35mm Carriage Bolts| 3#| 12| M8 Nylon Lock Nuts
2#| 12| M8 Large Flat Washers| 4#| 6| Sliders (Packed with Mounting Brackets)

STEP 1
Start installation from the passenger side front of the vehicle,remove the existing (2) factory bolts located by the front tire opening securing the factory rocker panel bracket to the vehicle, (Fig 1). STEP 2
Select the Passenger Front Mounting Bracket (PFM), attach the bracket to the vehicle by using the included (2) M8x1.25-30mm Hex Bolts, (2) M8 Lock Washers and (2) M8 Flat Washers, (Fig 2). Do not fully tighten hardware at this time.
STEP 3
Move along the side panel to the Driver Side Center and Rear Mounting Locations, (Fig 3). Repeat Steps 1 & 2 to install the  Mounting Brackets, (Fig 4).

STEP 4
Once all (3) Passenger side mounting brackets are installed, then proceed to the Step Bar installation. (Figs 5 & 6)

1. Select (1) Slider and (2) M8X1.25-35mm Carriage Bolts;
2. Install (2) M8X1.25-35mm Carriage Bolts in (1) Slider.
3. Slide the Slider (with carriage bolts) to the Step Bar.
4. Repeat to install the other (2) sliders to the step bar.
5. Attach the Step Bar (with the Sliders) onto the installed mounting brackets. Position the Sliders to the installed brackets. Secure the Step Bar to the installed Brackets by using (6) M8 Large Flat Washers and (6) M8 Nylon Lock Nuts and (3) Sliders, (Fig 6). Do not fully tighten hardware at this time.

Note: The Sliders are packed with the Mounting Brackets.
Level and adjust the Step Bar and fully tighten all hardware.
Repeat Steps 1-4 for the other side Step Bar installation. The installation is completed!!!
Attention
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
In order to protect your bars/boards, please use mild soap/non-abrasive products for cleaning only.

https://www.iboardauto.com/iboard-videos/
Customer Support: info@iboardauto.com
Rev. 20230901

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>