PHILIPS Ledinaire EcoSet for Offices LED Luminaires Owner’s Manual
- June 1, 2024
- Philips
Table of Contents
Ledinaire EcoSet
Quick start guide
Philips Ledinaire EcoSet for offices
a lighting brand by
Exemplary office area
Prepare the setup for a group
Make sure that the lighting plan will provide power for each group of lights.
Your options:
- Have a method to disconnect the group locally or
- Use the power control shown on the previous page
Independent power control for each group ensures a successful light setup.
Insert batteries in remote control and optional wall switch.
Remote: 2 × AA
Wall switch: 1 × CR2450
Optional:
Configure the settings via the dip switches on the back of the sensor.
Please refer to the mounting instructions of the sensor included in the box.
Install lights as per lighting plan.
You can turn on the lamps to test the electrical connection, but remember to
turn off all lamps before the next step.
Create a group of lights
- Turn the lights in the group off for 10 seconds. Make sure that no other lights are switched on.
- Turn the lights back on The red LED in the sensor unit lights up to indicate that the sensor is being powered up.
Wait until the sensor LED is turned off. This will take about 50 seconds.
Create a new group
Press the above buttons on the remote control for 10 seconds.
The red LED on the remote will light up.
The lights will dim quickly and return to 100% within 2 minutes.
No need to wait, let’s continue! Add a sensor Shortly prbutton on the sensor
No need to w
Add a sensor
Shortly press the above button on the sensor.
The LED on the sensor will blink for 1 minute while it searches for and
connects to the group.
No need to wait, let’s continue!
Optional step: Add a wall switch
Press the above buttons on the wall switch for 10 seconds.
The wall switch will search for and connect to the group.
Your group is ready when the red LED on the remote turns off. This will take 2
minutes.
Follow the instructions for testing the lights on the next page.
Execute these steps within 2 minutes, otherwise the setup will fail!
Test lights of the created group | 3 options
Test lights in the group
QUERY
Press the “Query” button on the remote to make the current group blink once.
Test the wall switch
Press “ON/OFF” or “+/-” buttons to operate the lights.
Please note:
After operating the wall switch the hold time is extended by 30 minutes.
Switch the light off and on again to be able to test the sensor immediately.
Test the sensor
Walk out of the room/sensor range.
Lights will dim after hold time, and switch off after 15 mins.
If the new setup does not work
Open the existing group
Press and hold the above button on the remote control.
The red LED on the remote will light up for 2 minutes.
Add sensor or wall switch
Follow the steps as described on page 4.
Add the devices within 2 minutes, otherwise the setup will fail!
For more troubleshooting advice, refer to the application manual at
philips.com/ledinaire
© 2023 Koninklijke Philips N.V. All rights reserved.
www.philips.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>