TAC 440900-1 4 Inch Oval Straight Sidebar Installation Guide
- June 1, 2024
- TAC
Table of Contents
TAC 440900-1 4 Inch Oval Straight Sidebar
PARTS LIST
| 1 | Driver/Left Sidebar | 8 | 8mm Lock Washers |
|---|---|---|---|
| 1 | Passenger/Right Sidebar | 8 | 8mm x 24mm OD x 2mm Flat Washers |
| 4 | Mounting Brackets | 8 | 8mm Hex Nuts |
| 8 | 8mm x 25mm Combo Bolts |
PROCEDURE
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY. CLEAN MOUNTING STUDS WITH WIRE BRUSH TO REMOVE PAINT AND DEBRIS.
- Starting on the Passenger/Right side front of the vehicle, (Figure 1). Attach (1) Mounting Bracket to the front location with (2) 8mm Flat Washers and (2) 8mm Flange Nuts, (Figure 2). Do not tighten hardware.
- Repeat Step 2 to attach (1) Mounting Bracket to the Passenger/Right rear location, (Figure 3).
- Select the Passenger/Right Sidebar. Carefully place Sidebar on the Mounting Brackets. IMPORTANT: Do not slide or rotate Sidebar on cradles, or damage to the finish may result. Attach Sidebar to the Mounting Brackets with (4) 8mm Combo Bolts, (Figure 4). Do not tighten hardware.
- Level and adjust the Sidebar and tighten all hardware.
- Repeat Steps 1—5 to attach the Driver/Left Sidebar.
- Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment , Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild soap may be used to clean the Sidebars.
Passenger/Right Side Installation Pictured
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>