Irrigatia Flat Irrigation Hose Instructions
- June 1, 2024
- Irrigatia
Table of Contents
Irrigatia Flat Irrigation Hose
Product Specifications
- 25m Flat irrigation hose
- 28 Tie straps 2.5mm x 100mm
- 24 ground-securing stakes
- 4 Tube / Tube connectors
- 10 Barb / Tube connectors
- 10 End stoppers
Product Usage Instructions
Cutting and Fitting the Irrigation Hose:
- Measure and cut the irrigation hose to the desired length.
- Install an End Stopper at one end and a Barb / Tube connector at at the other end of the hose.
- Steps to install both fittings:
- Open up the irrigation hose.
- Push the End Stopper or Barb Tube connector into the hose.
- Push it right up to the flange on the connector and secure a tie-strap around it.
- Pull tightly and trim if necessary.
- Connect the Barb / Tube connector to the main water feed tubing.
- Ensure fittings are secure.
Positioning and Securing the Hose
- Lay the irrigation hose on the ground as level as possible, following contours if needed.
- Use the provided plastic stakes to fix the hose in place.
- Avoid damaging the hose during cultivation.
- If needed, connect two lengths of hose using the Tube / Tubeconnector following the same process as above.
Care should be taken when cultivating around the hose, and any mulch covering
should be removed before cultivation if necessary.
The hose can remain in place over the winter for convenience.
For more information on this product or others in our range, please visit: irrigatia.com
Contents
How to use
The irrigation hose can be cut to whatever length is required.
The length of hose then needs BOTH an End Stopper fitted, and a Barb / Tube
connector (this connects to the main water feed tubing) for it to function.
Both are installed in the same way:
- Open up the irrigation hose
- Push the End Stopper or Barb Tube connector into the hose
- Push right up to the flange on the connector and secure a tie-strap around
- Pull tightly, trim if required
- Barb / Tube connector can then be connected to the main water feed tubing
- Completed fittings
Lay the length of irrigation hose on the ground as level as possible, following contours if necessary.
- Use plastic stakes provided to fix in place.
- Care should be taken not to damage the irrigation hose during cultivations. Scrape away any mulch covering before cultivation if necessary.
- The hose can be left in position over the winter.
- If required two lengths of hose can be connected using the Tube / Tube connector, same process as above.
For further information on this or any of the other products in our range, please visit: irrigatia.com
FAQ
Q: Can the irrigation hose be connected to a timer for automated watering?
A: Yes, you can connect the irrigation hose to a timer for scheduled watering. Make sure to use compatible connectors for this setup.
Q: How often should I check and maintain the irrigation system?
A: It is recommended to regularly inspect the system for leaks, clogs, or damages. Cleaning and flushing the system periodically can help maintain its efficiency.
References
- Irrigatia | Solar Powered-Weather Responsive-Irrigation Watering…
- Irrigatia | Irrigatia Flat Irrigation Hose Installation Instructions