ActronAir 657252 Interface Board ICUNO-MOD Installation Guide
- June 13, 2024
- ActronAir
Table of Contents
ActronAir 657252 Interface Board ICUNO-MOD
Product Information
Product Name: ActronAir Gateway Wiring
Item Number: 657252
Compatible with: ActronAir Interface Board ICUNO-MOD (for outdoor, purchased from ActronAir)
Product Usage Instructions
To install the ActronAir Gateway Wiring, please follow the steps below:
- Locate the ActronAir ICUNO-MOD board and ensure it is securely installed.
- Identify Gateway 657252 and ensure it is compatible with the ICUNO-MOD board.
- Connect the ActronAir ICUNO-MOD board to Gateway 657252 using the provided wiring harness.
- Ensure all connections are secure and properly aligned.
- Once the wiring is complete, double-check all connections to ensure they are properly seated.
- Refer to the ActronAir Interface Board ICUNO-MOD user manual for any additional configuration or setup requirements.
Note: It is essential to follow the manufacturer’s guidelines and consult the user manual for specific instructions related to your ActronAir Interface Board ICUNO-MOD.
Item# 657252 ActronAir Gateway Wiring
For ActronAir Interface Board ICUNO-MOD (for Outdoor, purchased from
ActronAir)
On ActronAir ICUNO-MOD board
- SW1: 00000000
- SW2: 0000
- SW3: 00
On Gateway 657252
- S1: 1000
- For connection to ICUNO-MOD: S2:0001
Notes:
- If the ActronAir wall controller is to be used with 657252, the card must be set with Basic BMS Control
- Connect the ActronAir Interface Board to the AC outdoor as per ActronAir’s instructions
- Disable Continuous Fan with Actron wall controller
- Wall controller or AERSS sensor should be installed
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>