Nederman FilterCart+ Mobile Welding Fume Extractor Instruction Manual
- June 1, 2024
- Nederman
Table of Contents
Nederman FilterCart+ Mobile Welding Fume Extractor Instruction Manual
Changing the filter cartridge
WARNING! Risk of personal injury.
Use necessary personal safety equipment when replacing the filter cartridges.
Follow local regulations
- Disconnect the mains connection cable.
- Unlock the eccentric locks and remove the filter casing.
- Use the plastic bag which comes with the new filter cartridge and pull it over the used cartridge. Fold the plastic bag under the cartridge.
- Use a duster to wipe off the filter cartridge contact surfaces in the FilterCart. Put the duster in the plastic bag with the filter cartridge and close the bag with the band supplied.
- Handle the used filter cartridge according to the relevant regulations for the substances that have been collected.
- Only for FilterCart W3: Check that the pressure drop hose (from the control board) not is damaged and is fitted properly.
- Check that the new filter cartridge is not damaged. Also check that the seal fitted on the underside of the cartridge is not damaged. Then fit the cartridge on the FilterCart.
- Refit the filter casing. Make sure the eccentric locks tighten the filter casing properly.
A. Increasing the locking power.
B. Decreasing the locking power.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>