THE HOME DEPOT HD62573 1 Light Brushed Nickel Semi Flush Mount Instruction Manual
- June 1, 2024
- THE HOME DEPOT
Table of Contents
ASSEMBLING & INSTALLATION
INSTRUCTIONS
HD62573 1 Light Brushed Nickel Semi Flush Mount
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
HD62573
- WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
- ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
MOUNTING THE FIXTURE (Fig.1)
- Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box.
- Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation.
- Attach the mounting plate to the junction box using two junction box screws as show. The side of the mounting plate marked “GND” must face out. The junction box is not included.
- Guide fixture wires through hole in center of mounting plate.
- Follow wiring instructions carefully (see fig.2).
- Place the glass(B) insert to the lamp holder, attach the check ring(C) insert to the socket wrench(D), lock them securely with the socket wrench(E), then remove the socket wrench and save it.
- Place the lamp body over the mounting plate, aligning the mounting holes with screw hole of the mounting plate on side, then lock it securely with the mounting screws.
- Install the light bulb(not included) in accordance with the fixture’s specifications. NOTE : DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
CONNECTING THE WIRES (Fig.2)
- Connect the electrical wires as follows. Connect the Black wire from the fixture to the black house (hot) Wire. Connect the white wire from the fixture to the white (neutral) house wire. Make sure all wire nuts are secured. You may wrap the connections with electrical tape. If your outlet box has a ground wires (green or bare copper) connect fixture’s ground wire to it. Otherwise attach the bare copper fixture wire to the green ground screw on the mounting plate.
- Tuck the wire connections neatly into the wall junction box.
Your installation is now complete. Return power to the junction box and test
the fixture.
Thank you for purchasing an AVIANCE product.
Need assistance with parts or assembly? Please email customer service
atinfo@aviancelighting.net
©COPYRIGHT ALL RIGHTS RESERVED. AVIANCE LIGHTING INC.
DOC202403HD62573
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>