LUCI TVW10700100061 Inox Basin Mixer Installation Guide
- June 1, 2024
- Luci
Table of Contents
LUCI TVW10700100061 Inox Basin Mixer
Product Specifications
- Model: LV.1000
- Model Number: KSQ101-12
Product Information
The LV.1000 model is a Luci installation kit designed for easy setup and use. It includes all necessary components for a successful installation.
Parts Identification
The kit includes various parts that are essential for the installation process. Please refer to the user manual for detailed information on each part and its function.
Luci Installation Instructions
- Begin by unpacking all the parts included in the kit and familiarize yourself with each component.
- Refer to the user manual for step-by-step instructions on how to assemble and install Luci.
- Ensure all connections are secure and follow safety guidelines during the installation process.
- Once installed, test Luci to ensure it is functioning correctly.
FAQs
Q: What should I do if a part is missing from the kit?
A: If you find any part missing from the kit, please contact our customer support for assistance. Make sure to have your purchase details ready.
Q: Can Luci be installed outdoors?
A: The LV.1000 Luci installation kit is designed for indoor use only. Installing it outdoors may void the warranty and compromise performance.
IMPORTANT!
Please read this instruction Prior to installation
PARTS IDENTIFICATION
INSTALLATION
- Flush the pipe work thoroughly prior to installation.
- Tighten the threaded fixing housing (Part 12) into the base of the mixer ensuring fixing housing is secure
- Screw the cold-only flexible tail (Part 7) into the underside of the mixer body and hand tighten .
- Fit O-Ring (Part 9) into the underside of the groove on the base flange (Part 8) .
- Centre the Base Flange + O-Ring (Part 8+9) centre of the hole of Basin or Benchtop prior to positioning the Mixer
- Place the Basin Mixer Into the groove on the base flange carefully position the threaded fixing housing and Cold Flexi Tail into the Hole of the basin or bench top .
- Hold the mixer in place at the top of Basin or bench top and position the rubber washer (Part 10) and then the Metal Washer (Part 11) over the threaded housing on the underside of basin or bench top
- Ensure the Mixer is in the correct position and hand tighten the Fixing Nut (Part 13) over the threaded housing ensuring the rubber washer compresses at the underside of the basin or bench top. A screw driver may be required to provide additional torque to the fixing nut to ensure it is tightened adequately .
- Once the basin mixer is in position and tightened, feed the hot flexi (Part 7) into the underside of the mixer body and hand tighten .
- Connect the flexible tails to firmly to the to the water supply connection, Turn on the water supply on and check for any leaks
IMPORTANT RECOMMENDATIONS FOR INSTALLATION
Installation should comply to AS/NZS3500.1 2003 or relevant local requirements. Not suitable for gravity feed application. Hot & cold water inlet pressures should be equal.
-
WATER PRESSURE
The operating static pressure is 150 – 500kpa. If the pressure exceeds this, then an approved pressure limiting valve must be installed. -
PRE-FLUSH
Always flush out the pipework before connecting any faucets. Damage caused to the faucet by debris coming through the pipework is not covered under warranty. -
WATER TEMPERATURE
The maximum hot water temperature is 75 degrees -
STOP TAP
Angle valves are recommended
ATTENTION!
Failure to do so will void the warranty.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>