DNBSS Nightstand with Charging Station and LED Lights Instruction Manual
- June 15, 2024
- DNBSS
Table of Contents
DNBSS Nightstand with Charging Station and LED Lights
PARTS AND TOOLS
INSTALLATION
-
Screw in the accessory 1 and 3 on the A 1 board.
-
Insert the B board and lock it with the accessory2. When installing, please note that the light wire is on the top. Lock right with a screwdriver
-
Note that the screw hole is downward
Screw in accessory 1 on the A2 board -
Insert the 3 and A2 board and lock it with the accessory 2Lock right with a screwdriver
-
Insert the D board and lock it with the accessory 2
Insert the rod 4 -
Pull out the light wire through the hole/ Insert the E board and lock it with the accessory 2Lock right with a screwdriver,
-
Screw in the accessory1 and 3 on F board
Insert the F board and lock it with the accessory -
Install wheels on the F-board
-
Screw in the accessory 1 and2 on G board
Insert the G board and lock it with the accessory (I) -
Install the edge stopper 7 Aand@) 10 the H board
-
Use screws12to fix the tube
-
Install the laptop tray to the iron pipe
-
Follow the steps to install the drawer.
-
Screw in two iron pins 13 to prevent the drawer from slipping
-
Connect the light wires as shown
-
100% Service: Full refund or free replacement for product(s) damaged on arrival, no return is needed, if you have any questions, PLEASE feel free to contact us.
User’s Guide
Thank you for purchasing this product. To use this product, please plug it
into a 12VDC power supply. Please use if the product works normally after
connecting to power.
Introduction
The box is an intelligent controller. It has 2 USB output ports and can
distribute the current output up to 5VDC-2A. With 2 touch buttons, it can turn
ON/OFF the light, change light colors, and adjust the light luminance.
Operation
This touch button is used to turn on/off, change colors, and adjust brightness. A. Short touch -> lighting on -> short touch -> change light color -> short touch -> change light color -> short touch -> lighting off. B. Long touch -> adjust the luminance
This touch button is used to turn on/off the induction function.
- Short touch to turn on the induction function. It can auto-turn on the light when people are close to the controller in 4 meters. It can auto-power off the light when the body is far away from the controller after 30 seconds.
- Long touch to turn off the induction function.
- Note: When you touch the light button to change the light modes, the induction function will automatically turn off. It is best to turn on this function after selecting the light color and adjusting the brightness you want.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>