CURT 45934 Adjustable Shank Dual Ball Mount Instruction Manual
- June 13, 2024
- Curt
Table of Contents
INSTALLATION MANUAL
45934
Level of Difficulty
Easy
Weight Capacity
| Gross trailer weight (GTW) | 20,000 lbs. |
|---|---|
| Tongue weight (TW) | 2,000 lbs. |
Parts List
| Item | Qty | Description |
|---|---|---|
| 1 | 1 | Adjustable shank* |
| 2 | 1 | Dual ball |
| 3 | 2 | Pin |
| 4 | 1 | Clip |
Tools Required
None
Maintenance
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
WARNING
Never exceed the vehicle manufacturer’s recommended towing capacity. The
ratings of the mount system are intended to represent the capability of the
product and in no way reflect the ratings or capacity of the towing system it
is being used with. The consumer or operator are strongly advised to learn the
ratings of the various components of the towing system and never exceed the
limits of the lowest rated component being used.
Never hook up trailer safety chains to the mount system. Ensure the safety
chains operate freely around the mount system and do not become entangled.
Product Photo
NOTICE
Before you begin installation, read all instructions thoroughly.
Prior to towing, ensure all fasteners are tight and all structural components
are sound.
Using a torque wrench and 3/8″ hex drive socket, torque hardware to 45-55 lb-
ft.
Product Registration
CURT Group stands behind our products with industry-leading warranties.
Provide feedback and help us to improve our products by registering your
purchase at:
warranty.curtgroup.com/surveys
ASSEMBLY & SETUP
Parts List
| Item | Qty | Description |
|---|---|---|
| 1 | 1 | Adjustable shank* |
| 2 | 1 | Dual ball |
| 3 | 2 | Pin |
| 4 | 1 | Clip |
*Sold separately
Step 1 – Insert into the Trailer Hitch
Begin by installing the shank (#1) into the trailer hitch receiver and secure
it with a hitch pin and clip (sold separately).
Step 2 – Determine Required Ball Height
Determine the proper ball height by leveling the trailer and measuring from
the bottom of the trailer tongue to the ground, see below.
Find the hole closest to that measurement on the adjustable shank (#1).
The trailer ball platform (#2) will be centered on that hole.
Step 3 – Attach the Tongue
Based on the determined ball height, slide the tongue onto the shank and align
with the proper hole locations.
Angle the tongue slightly upwards and press in toward the shank. Insert a pin
(#3) into the top tongue hole first. To pin the bottom tongue hole, apply
downward force to the tongue, and slide the second pin into place.
Note: The highest mounting position will require the bottom pin to be
installed first with the tongue angled downward. Then, apply force upwards to
install the second pin.
Secure all pins with the included clip (#4).
WARNING
The provided pins are specifically engineered for this system.
If replacement pins are needed, they must be replaced with original factory
mount pins (CURT# 45931).
CURTMFG.COM • PRODUCT SUPPORT: 877.287.8634 • 45933-INS- RA • 08/08/2022 • ECN9778
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>