SEALEY WL63-8D Rechargeable Dual Mounting Magnifying Worklight Instruction Manual
- June 1, 2024
- SEALEY
Table of Contents
SEALEY WL63-8D Rechargeable Dual Mounting Magnifying Worklight
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.
IMPORTANT
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR
THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE
FOR FUTURE USE.
SAFETY
- Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or damaged DO NOT use.
- Ensure the lamp is fully charged before initial use.
- DO NOT charge in damp conditions.
- DO NOT turn the lamp on when it is being charged.
- DO NOT shine directly into your, another person’s or an animal’s eyes.
- DO NOT allow children to use the lamp.
- DO NOT handle or move the lamp whilst it is being charged.
- DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
- DO NOT leave the battery in a discharged state, recharge the battery immediately. Before storage, fully recharge the battery, and subsequently recharge the battery at least once every six months of non-use.
- DO NOT attempt to open, disassemble, modify or service the battery pack.
- DO NOT crush, puncture, short external contacts or dispose of in fire or water.
- DO NOT expose to temperatures above 40°C (104°F).
INTRODUCTION
Powerful three-dioptre 109mm & eight-dioptre 24mm precision lens gives high- quality magnifying capabilities. Features six SMD LEDs producing up to 60 lumens to illuminate the object for improved detailed work. Built-in touch- sensitive dimmer switch. Magnifier can detach from its sturdy base and spring clamp to a workbench up to 45mm thick. Ideal for electrical engineers, engravers and fine detail work. Rechargeable 3.7V 400mAh lithium cell battery. Supplied with micro USB cable.
SPECIFICATION
OPERATION
CHARGING
- Connect the micro-USB lead to the socket on the side of the base of the lamp (fig.1). Plug into the USB power supply and turn it on.
- While the lamp is charging there is a red LED shining through the desk clamp surface just above the touch-sensitive switch.
- Direct the lens away from your eyes before switching on.
- Lightly tap the touchpad switch on the base to turn the lamp on. Lightly tap the touchpad switch again to turn it off.
- To modify the lamp output, press and hold the touchpad switch to dim or increase the light output.
- The lamp may be either desk mounted or attached to any desk/bench edge up to 45mm thick by exposing the clamp after removing the base plate.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools,
accessories and packaging should be sorted, taken to a recycling centre and
disposed of in a manner that is compatible with the environment. When the
product becomes completely unserviceable and requires disposal, drain any
fluids (if applicable) into approved containers and dispose of the product and
fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the
EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the
product is no longer required, it must be disposed of in an environmentally
protective way. Contact your local solid waste authority for recycling
information.
NOTE: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and parts without prior
notice.
IMPORTANT: No Liability is accepted for incorrect use of this product.
WARRANTY: The guarantee is 12 months from the purchase date, proof of
which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk.
IP32 7AR
01284 757500 sales@sealey.co.uk
www.sealey.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>